@@ -67,6 +67,9 @@ static void _dpu_encoder_phys_cmd_update_intf_cfg(
phys_enc->hw_intf->ops.bind_pingpong_blk(
phys_enc->hw_intf,
phys_enc->hw_pp->idx);
+
+ if (intf_cfg.dsc != 0 && phys_enc->hw_intf->ops.enable_compression)
+ phys_enc->hw_intf->ops.enable_compression(phys_enc->hw_intf);
}
static void dpu_encoder_phys_cmd_pp_tx_done_irq(void *arg, int irq_idx)
@@ -91,6 +91,7 @@
#define INTF_CFG2_DATABUS_WIDEN BIT(0)
#define INTF_CFG2_DATA_HCTL_EN BIT(4)
+#define INTF_CFG2_DCE_DATA_COMPRESS BIT(12)
static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *ctx,
@@ -512,6 +513,15 @@ static void dpu_hw_intf_disable_autorefresh(struct dpu_hw_intf *intf,
}
+static void dpu_hw_intf_enable_compression(struct dpu_hw_intf *ctx)
+{
+ u32 intf_cfg2 = DPU_REG_READ(&ctx->hw, INTF_CONFIG2);
+
+ intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;
+
+ DPU_REG_WRITE(&ctx->hw, INTF_CONFIG2, intf_cfg2);
+}
+
static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
unsigned long cap)
{
@@ -532,6 +542,9 @@ static void _setup_intf_ops(struct dpu_hw_intf_ops *ops,
ops->vsync_sel = dpu_hw_intf_vsync_sel;
ops->disable_autorefresh = dpu_hw_intf_disable_autorefresh;
}
+
+ if (cap & BIT(DPU_INTF_DATA_COMPRESS))
+ ops->enable_compression = dpu_hw_intf_enable_compression;
}
struct dpu_hw_intf *dpu_hw_intf_init(const struct dpu_intf_cfg *cfg,
@@ -70,6 +70,7 @@ struct intf_status {
* @get_autorefresh: Retrieve autorefresh config from hardware
* Return: 0 on success, -ETIMEDOUT on timeout
* @vsync_sel: Select vsync signal for tear-effect configuration
+ * @enable_compression: Enable data compression
*/
struct dpu_hw_intf_ops {
void (*setup_timing_gen)(struct dpu_hw_intf *intf,
@@ -106,6 +107,8 @@ struct dpu_hw_intf_ops {
* Disable autorefresh if enabled
*/
void (*disable_autorefresh)(struct dpu_hw_intf *intf, uint32_t encoder_id, u16 vdisplay);
+
+ void (*enable_compression)(struct dpu_hw_intf *intf);
};
struct dpu_hw_intf {
Add a DPU INTF op to set the DCE_DATA_COMPRESS bit to enable the DCE/DSC 1.2 datapath Note: For now, this op is called for command mode encoders only. Changes to set DATA_COMPRESS for video mode encoders will be posted along with DSC v1.2 support for DP. Signed-off-by: Jessica Zhang <quic_jesszhan@quicinc.com> --- drivers/gpu/drm/msm/disp/dpu1/dpu_encoder_phys_cmd.c | 3 +++ drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 13 +++++++++++++ drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.h | 3 +++ 3 files changed, 19 insertions(+)