| Message ID | 20241016221049.1145101-1-alexey.klimov@linaro.org |
|---|---|
| State | Accepted |
| Commit | 9fc9ef05727ccb45fd881770f2aa5c3774b2e8e2 |
| Headers | show |
| Series | [v2] ASoC: codecs: lpass-rx-macro: fix RXn(rx,n) macro for DSM_CTL and SEC7 regs | expand |
On Wed, Oct 16, 2024 at 11:10:49PM +0100, Alexey Klimov wrote: > Turns out some registers of pre-2.5 version of rxmacro codecs are not > located at the expected offsets but 0xc further away in memory. So far > the detected registers are CDC_RX_RX2_RX_PATH_SEC7 and > CDC_RX_RX2_RX_PATH_DSM_CTL. > > CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) macro incorrectly generates the address > 0x540 for RX2 but it should be 0x54C and it also overwrites > CDC_RX_RX2_RX_PATH_SEC7 which is located at 0x540. > The same goes for CDC_RX_RXn_RX_PATH_SEC7(rx, n). > > Fix this by introducing additional rxn_reg_stride2 offset. For 2.5 version > and above this offset will be equal to 0. > With such change the corresponding RXn() macros will generate the same > values for 2.5 codec version for all RX paths and the same old values > for pre-2.5 version for RX0 and RX1. However for the latter case with > RX2 path it will also add rxn_reg_stride2 on top. > > While at this, also remove specific if-check for INTERP_AUX from > rx_macro_digital_mute() and rx_macro_enable_interp_clk(). These if-check > was used to handle such special offset for AUX interpolator but since > CDC_RX_RXn_RX_PATH_SEC7(rx, n) and CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) > macros will generate the correst addresses of dsm register, they are no > longer needed. > > Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> > Cc: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> > Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org> > --- > Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
On Wed, 16 Oct 2024 23:10:49 +0100, Alexey Klimov wrote: > Turns out some registers of pre-2.5 version of rxmacro codecs are not > located at the expected offsets but 0xc further away in memory. So far > the detected registers are CDC_RX_RX2_RX_PATH_SEC7 and > CDC_RX_RX2_RX_PATH_DSM_CTL. > > CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) macro incorrectly generates the address > 0x540 for RX2 but it should be 0x54C and it also overwrites > CDC_RX_RX2_RX_PATH_SEC7 which is located at 0x540. > The same goes for CDC_RX_RXn_RX_PATH_SEC7(rx, n). > > [...] Applied to https://git.kernel.org/pub/scm/linux/kernel/git/broonie/sound.git for-next Thanks! [1/1] ASoC: codecs: lpass-rx-macro: fix RXn(rx,n) macro for DSM_CTL and SEC7 regs commit: 9fc9ef05727ccb45fd881770f2aa5c3774b2e8e2 All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted. You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed. If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced. Please add any relevant lists and maintainers to the CCs when replying to this mail. Thanks, Mark
diff --git a/sound/soc/codecs/lpass-rx-macro.c b/sound/soc/codecs/lpass-rx-macro.c index ef7a70fa6966..febbbe073962 100644 --- a/sound/soc/codecs/lpass-rx-macro.c +++ b/sound/soc/codecs/lpass-rx-macro.c @@ -202,12 +202,14 @@ #define CDC_RX_RXn_RX_PATH_SEC3(rx, n) (0x042c + rx->rxn_reg_stride * n) #define CDC_RX_RX0_RX_PATH_SEC4 (0x0430) #define CDC_RX_RX0_RX_PATH_SEC7 (0x0434) -#define CDC_RX_RXn_RX_PATH_SEC7(rx, n) (0x0434 + rx->rxn_reg_stride * n) +#define CDC_RX_RXn_RX_PATH_SEC7(rx, n) \ + (0x0434 + (rx->rxn_reg_stride * n) + ((n > 1) ? rx->rxn_reg_stride2 : 0)) #define CDC_RX_DSM_OUT_DELAY_SEL_MASK GENMASK(2, 0) #define CDC_RX_DSM_OUT_DELAY_TWO_SAMPLE 0x2 #define CDC_RX_RX0_RX_PATH_MIX_SEC0 (0x0438) #define CDC_RX_RX0_RX_PATH_MIX_SEC1 (0x043C) -#define CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) (0x0440 + rx->rxn_reg_stride * n) +#define CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) \ + (0x0440 + (rx->rxn_reg_stride * n) + ((n > 1) ? rx->rxn_reg_stride2 : 0)) #define CDC_RX_RXn_DSM_CLK_EN_MASK BIT(0) #define CDC_RX_RX0_RX_PATH_DSM_CTL (0x0440) #define CDC_RX_RX0_RX_PATH_DSM_DATA1 (0x0444) @@ -645,6 +647,7 @@ struct rx_macro { int rx_mclk_cnt; enum lpass_codec_version codec_version; int rxn_reg_stride; + int rxn_reg_stride2; bool is_ear_mode_on; bool hph_pwr_mode; bool hph_hd2_mode; @@ -1929,9 +1932,6 @@ static int rx_macro_digital_mute(struct snd_soc_dai *dai, int mute, int stream) CDC_RX_PATH_PGA_MUTE_MASK, 0x0); } - if (j == INTERP_AUX) - dsm_reg = CDC_RX_RXn_RX_PATH_DSM_CTL(rx, 2); - int_mux_cfg0 = CDC_RX_INP_MUX_RX_INT0_CFG0 + j * 8; int_mux_cfg1 = int_mux_cfg0 + 4; int_mux_cfg0_val = snd_soc_component_read(component, int_mux_cfg0); @@ -2702,9 +2702,6 @@ static int rx_macro_enable_interp_clk(struct snd_soc_component *component, main_reg = CDC_RX_RXn_RX_PATH_CTL(rx, interp_idx); dsm_reg = CDC_RX_RXn_RX_PATH_DSM_CTL(rx, interp_idx); - if (interp_idx == INTERP_AUX) - dsm_reg = CDC_RX_RXn_RX_PATH_DSM_CTL(rx, 2); - rx_cfg2_reg = CDC_RX_RXn_RX_PATH_CFG2(rx, interp_idx); if (SND_SOC_DAPM_EVENT_ON(event)) { @@ -3821,6 +3818,7 @@ static int rx_macro_probe(struct platform_device *pdev) case LPASS_CODEC_VERSION_2_0: case LPASS_CODEC_VERSION_2_1: rx->rxn_reg_stride = 0x80; + rx->rxn_reg_stride2 = 0xc; def_count = ARRAY_SIZE(rx_defaults) + ARRAY_SIZE(rx_pre_2_5_defaults); reg_defaults = kmalloc_array(def_count, sizeof(struct reg_default), GFP_KERNEL); if (!reg_defaults) @@ -3834,6 +3832,7 @@ static int rx_macro_probe(struct platform_device *pdev) case LPASS_CODEC_VERSION_2_7: case LPASS_CODEC_VERSION_2_8: rx->rxn_reg_stride = 0xc0; + rx->rxn_reg_stride2 = 0x0; def_count = ARRAY_SIZE(rx_defaults) + ARRAY_SIZE(rx_2_5_defaults); reg_defaults = kmalloc_array(def_count, sizeof(struct reg_default), GFP_KERNEL); if (!reg_defaults)
Turns out some registers of pre-2.5 version of rxmacro codecs are not located at the expected offsets but 0xc further away in memory. So far the detected registers are CDC_RX_RX2_RX_PATH_SEC7 and CDC_RX_RX2_RX_PATH_DSM_CTL. CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) macro incorrectly generates the address 0x540 for RX2 but it should be 0x54C and it also overwrites CDC_RX_RX2_RX_PATH_SEC7 which is located at 0x540. The same goes for CDC_RX_RXn_RX_PATH_SEC7(rx, n). Fix this by introducing additional rxn_reg_stride2 offset. For 2.5 version and above this offset will be equal to 0. With such change the corresponding RXn() macros will generate the same values for 2.5 codec version for all RX paths and the same old values for pre-2.5 version for RX0 and RX1. However for the latter case with RX2 path it will also add rxn_reg_stride2 on top. While at this, also remove specific if-check for INTERP_AUX from rx_macro_digital_mute() and rx_macro_enable_interp_clk(). These if-check was used to handle such special offset for AUX interpolator but since CDC_RX_RXn_RX_PATH_SEC7(rx, n) and CDC_RX_RXn_RX_PATH_DSM_CTL(rx, n) macros will generate the correst addresses of dsm register, they are no longer needed. Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org> Cc: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org> --- Changes in v2: - updated macros as suggested by Mark and Dmitry; - removed INTERP_AUX if-check in two functions; Link to previous patch: https://lore.kernel.org/lkml/20240925043823.520218-1-alexey.klimov@linaro.org/ sound/soc/codecs/lpass-rx-macro.c | 15 +++++++-------- 1 file changed, 7 insertions(+), 8 deletions(-)