@@ -15,7 +15,6 @@
#include <linux/init.h>
#include <linux/module.h>
#include <linux/amba/bus.h>
-#include <linux/atomic.h>
#include <linux/slab.h>
#include <linux/interrupt.h>
#include <linux/i2c.h>
@@ -981,8 +980,6 @@ static void nmk_i2c_of_probe(struct device_node *np,
pdata->sm = I2C_FREQ_MODE_FAST;
}
-static atomic_t adapter_id = ATOMIC_INIT(0);
-
static int nmk_i2c_probe(struct amba_device *adev, const struct amba_id *id)
{
int ret = 0;
@@ -1095,10 +1092,9 @@ static int nmk_i2c_probe(struct amba_device *adev, const struct amba_id *id)
adap->class = I2C_CLASS_HWMON | I2C_CLASS_SPD;
adap->algo = &nmk_i2c_algo;
adap->timeout = msecs_to_jiffies(pdata->timeout);
- adap->nr = atomic_read(&adapter_id);
+ adap->nr = -1;
snprintf(adap->name, sizeof(adap->name),
- "Nomadik I2C%d at %pR", adap->nr, &adev->res);
- atomic_inc(&adapter_id);
+ "Nomadik I2C at %pR", &adev->res);
/* fetch the controller configuration from machine */
dev->cfg.clk_freq = pdata->clk_freq;
@@ -1113,7 +1109,7 @@ static int nmk_i2c_probe(struct amba_device *adev, const struct amba_id *id)
"initialize %s on virtual base %p\n",
adap->name, dev->virtbase);
- ret = i2c_add_numbered_adapter(adap);
+ ret = i2c_add_adapter(adap);
if (ret) {
dev_err(&adev->dev, "failed to add adapter\n");
goto err_add_adap;
The Nomadik I2C was using a local atomic counter to number the I2C adapters. This does not work on configurations where you also add, say a GPIO bit-banged adapter to the system. They will start to conflict about being adapter 0. There is no reason to use the numbered adapter function, and the semantic effect on systems with only Nomadik I2C blocks will be none - instead of increasing the number atomically in the driver itself, it is done in the I2C core. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- drivers/i2c/busses/i2c-nomadik.c | 10 +++------- 1 file changed, 3 insertions(+), 7 deletions(-)