diff mbox series

[v2,2/3] dt-bindings: phy: ti,phy-j721e-wiz: Add Type-C dir GPIO

Message ID 20191023084916.26895-3-rogerq@ti.com
State New
Headers show
Series phy: cadence: j721e-wiz: Add Type-C plug flip support | expand

Commit Message

Roger Quadros Oct. 23, 2019, 8:49 a.m. UTC 
This is an optional GPIO, if specified will be used to
swap lane 0 and lane 1 based on GPIO status. This is required
to achieve plug flip support for USB Type-C.

Type-C companions typically need some time after the cable is
plugged before and before they reflect the correct status of
Type-C plug orientation on the DIR line.

Type-C Spec specifies CC attachment debounce time (tCCDebounce)
of 100 ms (min) to 200 ms (max).

Allow the DT node to specify the time (in ms) that we need
to wait before sampling the DIR line.

Signed-off-by: Roger Quadros <rogerq@ti.com>

Signed-off-by: Sekhar Nori <nsekhar@ti.com>

---
 .../devicetree/bindings/phy/ti,phy-j721e-wiz.txt         | 9 +++++++++
 1 file changed, 9 insertions(+)

-- 
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/phy/ti,phy-j721e-wiz.txt b/Documentation/devicetree/bindings/phy/ti,phy-j721e-wiz.txt
index 19b4c3e855d6..253535a8819f 100644
--- a/Documentation/devicetree/bindings/phy/ti,phy-j721e-wiz.txt
+++ b/Documentation/devicetree/bindings/phy/ti,phy-j721e-wiz.txt
@@ -24,6 +24,15 @@  Optional properties:
 assigned-clocks and assigned-clock-parents: As documented in the generic
 clock bindings in Documentation/devicetree/bindings/clock/clock-bindings.txt
 
+ - typec-dir-gpios: GPIO to signal Type-C cable orientation for lane swap.
+     If GPIO is active, lane 0 and lane 1 of SERDES will be swapped to
+     achieve the funtionality of an exernal type-C plug flip mux.
+
+ - typec-dir-debounce: Number of milliseconds to wait before sampling
+     typec-dir-gpio. If not specified, the GPIO will be sampled ASAP.
+     Type-C spec states minimum CC pin debounce of 100 ms and maximum
+     of 200 ms.
+
 Required subnodes:
  - Clock Subnode: WIZ node should have '3' subnodes for each of the clock
      selects it supports. The clock subnodes should have the following names