@@ -53,15 +53,15 @@ static unsigned int omap_getspeed(unsigned int cpu)
static int omap_target(struct cpufreq_policy *policy, unsigned int index)
{
- int r, ret = 0;
- struct cpufreq_freqs freqs;
+ int r, ret;
struct opp *opp;
unsigned long freq, volt = 0, volt_old = 0, tol = 0;
+ unsigned int old_freq, new_freq;
- freqs.old = omap_getspeed(policy->cpu);
- freqs.new = freq_table[index].frequency;
+ old_freq = omap_getspeed(policy->cpu);
+ new_freq = freq_table[index].frequency;
- freq = freqs.new * 1000;
+ freq = new_freq * 1000;
ret = clk_round_rate(mpu_clk, freq);
if (IS_ERR_VALUE(ret)) {
dev_warn(mpu_dev,
@@ -77,7 +77,7 @@ static int omap_target(struct cpufreq_policy *policy, unsigned int index)
if (IS_ERR(opp)) {
rcu_read_unlock();
dev_err(mpu_dev, "%s: unable to find MPU OPP for %d\n",
- __func__, freqs.new);
+ __func__, new_freq);
return -EINVAL;
}
volt = opp_get_voltage(opp);
@@ -87,43 +87,32 @@ static int omap_target(struct cpufreq_policy *policy, unsigned int index)
}
dev_dbg(mpu_dev, "cpufreq-omap: %u MHz, %ld mV --> %u MHz, %ld mV\n",
- freqs.old / 1000, volt_old ? volt_old / 1000 : -1,
- freqs.new / 1000, volt ? volt / 1000 : -1);
-
- /* notifiers */
- cpufreq_notify_transition(policy, &freqs, CPUFREQ_PRECHANGE);
+ old_freq / 1000, volt_old ? volt_old / 1000 : -1,
+ new_freq / 1000, volt ? volt / 1000 : -1);
/* scaling up? scale voltage before frequency */
- if (mpu_reg && (freqs.new > freqs.old)) {
+ if (mpu_reg && (new_freq > old_freq)) {
r = regulator_set_voltage(mpu_reg, volt - tol, volt + tol);
if (r < 0) {
dev_warn(mpu_dev, "%s: unable to scale voltage up.\n",
__func__);
- freqs.new = freqs.old;
- goto done;
+ return r;
}
}
- ret = clk_set_rate(mpu_clk, freqs.new * 1000);
+ ret = clk_set_rate(mpu_clk, new_freq * 1000);
/* scaling down? scale voltage after frequency */
- if (mpu_reg && (freqs.new < freqs.old)) {
+ if (mpu_reg && (new_freq < old_freq)) {
r = regulator_set_voltage(mpu_reg, volt - tol, volt + tol);
if (r < 0) {
dev_warn(mpu_dev, "%s: unable to scale voltage down.\n",
__func__);
- ret = clk_set_rate(mpu_clk, freqs.old * 1000);
- freqs.new = freqs.old;
- goto done;
+ clk_set_rate(mpu_clk, old_freq * 1000);
+ return r;
}
}
- freqs.new = omap_getspeed(policy->cpu);
-
-done:
- /* notifiers */
- cpufreq_notify_transition(policy, &freqs, CPUFREQ_POSTCHANGE);
-
return ret;
}
Most of the drivers do following in their ->target_index() routines: struct cpufreq_freqs freqs; freqs.old = old freq... freqs.new = new freq... cpufreq_notify_transition(policy, &freqs, CPUFREQ_PRECHANGE); /* Change rate here */ cpufreq_notify_transition(policy, &freqs, CPUFREQ_POSTCHANGE); This is replicated over all cpufreq drivers today and there doesn't exists a good enough reason why this shouldn't be moved to cpufreq core instead. Earlier patches have added support in cpufreq core to do cpufreq notification on frequency change, this one removes it from this driver. Some related minor cleanups are also done along with it. Cc: Santosh Shilimkar <santosh.shilimkar@ti.com> Signed-off-by: Viresh Kumar <viresh.kumar@linaro.org> --- drivers/cpufreq/omap-cpufreq.c | 39 ++++++++++++++------------------------- 1 file changed, 14 insertions(+), 25 deletions(-)