@@ -273,7 +273,7 @@ static void pxa2xx_pwrmode_write(CPUARMState *env, const ARMCPRegInfo *ri,
case 3:
s->cpu->env.uncached_cpsr = ARM_CPU_MODE_SVC;
s->cpu->env.daif = PSTATE_A | PSTATE_F | PSTATE_I;
- s->cpu->env.cp15.c1_sys = 0;
+ s->cpu->env.cp15.sctlr_ns = 0;
s->cpu->env.cp15.c1_coproc = 0;
s->cpu->env.cp15.ttbr0_el1 = 0;
s->cpu->env.cp15.c3 = 0;
@@ -109,7 +109,7 @@ static void arm_cpu_reset(CPUState *s)
#if defined(CONFIG_USER_ONLY)
env->pstate = PSTATE_MODE_EL0t;
/* Userspace expects access to DC ZVA, CTL_EL0 and the cache ops */
- env->cp15.c1_sys |= SCTLR_UCT | SCTLR_UCI | SCTLR_DZE;
+ env->cp15.sctlr_el[1] |= SCTLR_UCT | SCTLR_UCI | SCTLR_DZE;
/* and to the FP/Neon instructions */
env->cp15.c1_coproc = deposit64(env->cp15.c1_coproc, 20, 2, 3);
#else
@@ -167,7 +167,11 @@ static void arm_cpu_reset(CPUState *s)
env->thumb = initial_pc & 1;
}
- if (env->cp15.c1_sys & SCTLR_V) {
+ /* AArch32 has a hard highvec setting of 0xFFFF0000. If we are currently
+ * executing as AArch32 then check if highvecs are enabled and
+ * adjust the PC accordingly.
+ */
+ if (A32_BANKED_CURRENT_REG_GET(env, sctlr) & SCTLR_V) {
env->regs[15] = 0xFFFF0000;
}
@@ -178,7 +178,15 @@ typedef struct CPUARMState {
struct {
uint32_t c0_cpuid;
uint64_t c0_cssel; /* Cache size selection. */
- uint64_t c1_sys; /* System control register. */
+ union { /* System control register. */
+ struct {
+ uint64_t _unused_sctlr;
+ uint64_t sctlr_ns;
+ uint64_t hsctlr;
+ uint64_t sctlr_s;
+ };
+ uint64_t sctlr_el[4];
+ };
uint64_t c1_coproc; /* Coprocessor access register. */
uint32_t c1_xscaleauxcr; /* XScale auxiliary control register. */
uint64_t sder; /* Secure debug enable register. */
@@ -1908,7 +1908,7 @@ static void aa64_fpsr_write(CPUARMState *env, const ARMCPRegInfo *ri,
static CPAccessResult aa64_daif_access(CPUARMState *env, const ARMCPRegInfo *ri)
{
- if (arm_current_el(env) == 0 && !(env->cp15.c1_sys & SCTLR_UMA)) {
+ if (arm_current_el(env) == 0 && !(env->cp15.sctlr_el[1] & SCTLR_UMA)) {
return CP_ACCESS_TRAP;
}
return CP_ACCESS_OK;
@@ -1926,7 +1926,7 @@ static CPAccessResult aa64_cacheop_access(CPUARMState *env,
/* Cache invalidate/clean: NOP, but EL0 must UNDEF unless
* SCTLR_EL1.UCI is set.
*/
- if (arm_current_el(env) == 0 && !(env->cp15.c1_sys & SCTLR_UCI)) {
+ if (arm_current_el(env) == 0 && !(env->cp15.sctlr_el[1] & SCTLR_UCI)) {
return CP_ACCESS_TRAP;
}
return CP_ACCESS_OK;
@@ -2003,7 +2003,7 @@ static CPAccessResult aa64_zva_access(CPUARMState *env, const ARMCPRegInfo *ri)
/* We don't implement EL2, so the only control on DC ZVA is the
* bit in the SCTLR which can prohibit access for EL0.
*/
- if (arm_current_el(env) == 0 && !(env->cp15.c1_sys & SCTLR_DZE)) {
+ if (arm_current_el(env) == 0 && !(env->cp15.sctlr_el[1] & SCTLR_DZE)) {
return CP_ACCESS_TRAP;
}
return CP_ACCESS_OK;
@@ -2042,6 +2042,24 @@ static void spsel_write(CPUARMState *env, const ARMCPRegInfo *ri, uint64_t val)
update_spsel(env, val);
}
+static void sctlr_write(CPUARMState *env, const ARMCPRegInfo *ri,
+ uint64_t value)
+{
+ ARMCPU *cpu = arm_env_get_cpu(env);
+
+ if (raw_read(env, ri) == value) {
+ /* Skip the TLB flush if nothing actually changed; Linux likes
+ * to do a lot of pointless SCTLR writes.
+ */
+ return;
+ }
+
+ raw_write(env, ri, value);
+ /* ??? Lots of these bits are not implemented. */
+ /* This may enable/disable the MMU, so do a TLB flush. */
+ tlb_flush(CPU(cpu), 1);
+}
+
static const ARMCPRegInfo v8_cp_reginfo[] = {
/* Minimal set of EL0-visible registers. This will need to be expanded
* significantly for system emulation of AArch64 CPUs.
@@ -2311,6 +2329,10 @@ static const ARMCPRegInfo v8_el2_cp_reginfo[] = {
};
static const ARMCPRegInfo v8_el3_cp_reginfo[] = {
+ { .name = "SCTLR_EL3", .state = ARM_CP_STATE_AA64,
+ .opc0 = 3, .opc1 = 6, .crn = 1, .crm = 0, .opc2 = 0,
+ .access = PL3_RW, .raw_writefn = raw_write, .writefn = sctlr_write,
+ .fieldoffset = offsetof(CPUARMState, cp15.sctlr_el[3]) },
{ .name = "ELR_EL3", .state = ARM_CP_STATE_AA64,
.type = ARM_CP_NO_MIGRATE,
.opc0 = 3, .opc1 = 6, .crn = 4, .crm = 0, .opc2 = 1,
@@ -2362,30 +2384,12 @@ static const ARMCPRegInfo el3_cp_reginfo[] = {
REGINFO_SENTINEL
};
-static void sctlr_write(CPUARMState *env, const ARMCPRegInfo *ri,
- uint64_t value)
-{
- ARMCPU *cpu = arm_env_get_cpu(env);
-
- if (raw_read(env, ri) == value) {
- /* Skip the TLB flush if nothing actually changed; Linux likes
- * to do a lot of pointless SCTLR writes.
- */
- return;
- }
-
- raw_write(env, ri, value);
- /* ??? Lots of these bits are not implemented. */
- /* This may enable/disable the MMU, so do a TLB flush. */
- tlb_flush(CPU(cpu), 1);
-}
-
static CPAccessResult ctr_el0_access(CPUARMState *env, const ARMCPRegInfo *ri)
{
/* Only accessible in EL0 if SCTLR.UCT is set (and only in AArch64,
* but the AArch32 CTR has its own reginfo struct)
*/
- if (arm_current_el(env) == 0 && !(env->cp15.c1_sys & SCTLR_UCT)) {
+ if (arm_current_el(env) == 0 && !(env->cp15.sctlr_el[1] & SCTLR_UCT)) {
return CP_ACCESS_TRAP;
}
return CP_ACCESS_OK;
@@ -3182,8 +3186,10 @@ void register_cp_regs_for_features(ARMCPU *cpu)
{
ARMCPRegInfo sctlr = {
.name = "SCTLR", .state = ARM_CP_STATE_BOTH,
- .opc0 = 3, .crn = 1, .crm = 0, .opc1 = 0, .opc2 = 0,
- .access = PL1_RW, .fieldoffset = offsetof(CPUARMState, cp15.c1_sys),
+ .cp = 15, .opc1 = 0, .crn = 1, .crm = 0, .opc2 = 0,
+ .access = PL1_RW,
+ .bank_fieldoffsets = { offsetof(CPUARMState, cp15.sctlr_s),
+ offsetof(CPUARMState, cp15.sctlr_ns) },
.writefn = sctlr_write, .resetvalue = cpu->reset_sctlr,
.raw_writefn = raw_write,
};
@@ -4278,7 +4284,7 @@ void arm_cpu_do_interrupt(CPUState *cs)
if (new_mode == ARM_CPU_MODE_MON) {
addr += env->cp15.mvbar;
- } else if (env->cp15.c1_sys & SCTLR_V) {
+ } else if (A32_BANKED_CURRENT_REG_GET(env, sctlr) & SCTLR_V) {
/* High vectors. When enabled, base address cannot be remapped. */
addr += 0xffff0000;
} else {
@@ -4308,7 +4314,7 @@ void arm_cpu_do_interrupt(CPUState *cs)
/* this is a lie, as the was no c1_sys on V4T/V5, but who cares
* and we should just guard the thumb mode on V4 */
if (arm_feature(env, ARM_FEATURE_V4T)) {
- env->thumb = (env->cp15.c1_sys & SCTLR_TE) != 0;
+ env->thumb = (A32_BANKED_CURRENT_REG_GET(env, sctlr) & SCTLR_TE) != 0;
}
env->regs[14] = env->regs[15] + offset;
env->regs[15] = addr;
@@ -4339,7 +4345,7 @@ static inline int check_ap(CPUARMState *env, int ap, int domain_prot,
}
if (access_type == 1)
return 0;
- switch (env->cp15.c1_sys & (SCTLR_S | SCTLR_R)) {
+ switch (A32_BANKED_CURRENT_REG_GET(env, sctlr) & (SCTLR_S | SCTLR_R)) {
case SCTLR_S:
return is_user ? 0 : PAGE_READ;
case SCTLR_R:
@@ -4588,7 +4594,8 @@ static int get_phys_addr_v6(CPUARMState *env, uint32_t address, int access_type,
goto do_fault;
/* The simplified model uses AP[0] as an access control bit. */
- if ((env->cp15.c1_sys & SCTLR_AFE) && (ap & 1) == 0) {
+ if ((A32_BANKED_CURRENT_REG_GET(env, sctlr) & SCTLR_AFE)
+ && (ap & 1) == 0) {
/* Access flag fault. */
code = (code == 15) ? 6 : 3;
goto do_fault;
@@ -4919,11 +4926,16 @@ static inline int get_phys_addr(CPUARMState *env, target_ulong address,
hwaddr *phys_ptr, int *prot,
target_ulong *page_size)
{
+ /* This is not entirely correct as get_phys_addr() can also be called
+ * from ats_write() for an address translation of a specific regime.
+ */
+ uint32_t sctlr = A32_BANKED_CURRENT_REG_GET(env, sctlr);
+
/* Fast Context Switch Extension. */
if (address < 0x02000000)
address += env->cp15.c13_fcse;
- if ((env->cp15.c1_sys & SCTLR_M) == 0) {
+ if ((sctlr & SCTLR_M) == 0) {
/* MMU/MPU disabled. */
*phys_ptr = address;
*prot = PAGE_READ | PAGE_WRITE | PAGE_EXEC;
@@ -4936,7 +4948,7 @@ static inline int get_phys_addr(CPUARMState *env, target_ulong address,
} else if (extended_addresses_enabled(env)) {
return get_phys_addr_lpae(env, address, access_type, is_user, phys_ptr,
prot, page_size);
- } else if (env->cp15.c1_sys & SCTLR_XP) {
+ } else if (sctlr & SCTLR_XP) {
return get_phys_addr_v6(env, address, access_type, is_user, phys_ptr,
prot, page_size);
} else {
@@ -361,7 +361,7 @@ void HELPER(msr_i_pstate)(CPUARMState *env, uint32_t op, uint32_t imm)
* Note that SPSel is never OK from EL0; we rely on handle_msr_i()
* to catch that case at translate time.
*/
- if (arm_current_el(env) == 0 && !(env->cp15.c1_sys & SCTLR_UMA)) {
+ if (arm_current_el(env) == 0 && !(env->cp15.sctlr_el[1] & SCTLR_UMA)) {
raise_exception(env, EXCP_UDEF);
}