@@ -59,7 +59,7 @@ Declare the I2C devices via ACPI
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
ACPI can also describe I2C devices. There is special documentation for this
-which is currently located at :doc:`../firmware-guide/acpi/enumeration`.
+which is currently located at Documentation/firmware-guide/acpi/enumeration.rst.
Declare the I2C devices in board files
@@ -17,7 +17,8 @@ address), ``force`` (to forcibly attach the driver to a given device) and
With the conversion of the I2C subsystem to the standard device driver
binding model, it became clear that these per-module parameters were no
longer needed, and that a centralized implementation was possible. The new,
-sysfs-based interface is described in :doc:`instantiating-devices`, section
+sysfs-based interface is described in
+Documentation/i2c/instantiating-devices.rst, section
"Method 4: Instantiate from user-space".
Below is a mapping from the old module parameters to the new interface.
@@ -27,8 +27,8 @@ a different protocol operation entirely.
Each transaction type corresponds to a functionality flag. Before calling a
transaction function, a device driver should always check (just once) for
the corresponding functionality flag to ensure that the underlying I2C
-adapter supports the transaction in question. See :doc:`functionality` for
-the details.
+adapter supports the transaction in question. See
+Documentation/i2c/functionality.rst for the details.
Key to symbols
The :doc:`foo` tag is auto-generated via automarkup.py. So, use the filename at the sources, instead of :doc:`foo`. Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org> --- Documentation/i2c/instantiating-devices.rst | 2 +- Documentation/i2c/old-module-parameters.rst | 3 ++- Documentation/i2c/smbus-protocol.rst | 4 ++-- 3 files changed, 5 insertions(+), 4 deletions(-)