diff mbox

[PATCH-V2,02/12] i2c: pxa: No need to set slave addr for i2c master mode reset

Message ID 1434383399-2370-3-git-send-email-vaibhav.hiremath@linaro.org
State New
Headers show

Commit Message

Vaibhav Hiremath June 15, 2015, 3:49 p.m. UTC
Normally i2c controller works as master, so slave addr is not needed, or it
will impact some slave device (eg. ST NFC chip) i2c accesses, because it has
the same i2c address with controller.

Signed-off-by: Jett.Zhou <jtzhou@marvell.com>
Signed-off-by: Vaibhav Hiremath <vaibhav.hiremath@linaro.org>
Cc: Wolfram Sang <wsa@the-dreams.de>
---
 drivers/i2c/busses/i2c-pxa.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
diff mbox

Patch

diff --git a/drivers/i2c/busses/i2c-pxa.c b/drivers/i2c/busses/i2c-pxa.c
index f4ac8c5..023e59f 100644
--- a/drivers/i2c/busses/i2c-pxa.c
+++ b/drivers/i2c/busses/i2c-pxa.c
@@ -459,7 +459,7 @@  static void i2c_pxa_reset(struct pxa_i2c *i2c)
 	writel(I2C_ISR_INIT, _ISR(i2c));
 	writel(readl(_ICR(i2c)) & ~ICR_UR, _ICR(i2c));
 
-	if (i2c->reg_isar)
+	if (i2c->reg_isar && IS_ENABLED(CONFIG_I2C_PXA_SLAVE))
 		writel(i2c->slave_addr, _ISAR(i2c));
 
 	/* set control register values */