@@ -107,7 +107,7 @@ static void channel_swdemux_tsklet(struct tasklet_struct *t)
size,
DMA_FROM_DEVICE);
- buf = (u8 *) channel->back_buffer_aligned;
+ buf = channel->back_buffer_aligned;
dev_dbg(fei->dev,
"chan=%d channel=%p num_packets = %d, buf = %p, pos = 0x%x\n\trp=0x%lx, wp=0x%lx\n",
@@ -176,7 +176,7 @@ static int c8sectpfe_start_feed(struct dvb_demux_feed *dvbdmxfeed)
channel = fei->channel_data[stdemux->tsin_index];
- bitmap = (unsigned long *) channel->pid_buffer_aligned;
+ bitmap = channel->pid_buffer_aligned;
/* 8192 is a special PID */
if (dvbdmxfeed->pid == 8192) {
@@ -272,7 +272,7 @@ static int c8sectpfe_stop_feed(struct dvb_demux_feed *dvbdmxfeed)
channel = fei->channel_data[stdemux->tsin_index];
- bitmap = (unsigned long *) channel->pid_buffer_aligned;
+ bitmap = channel->pid_buffer_aligned;
if (dvbdmxfeed->pid == 8192) {
tmp = readl(fei->io + C8SECTPFE_IB_PID_SET(channel->tsin_id));
@@ -333,8 +333,7 @@ static int c8sectpfe_stop_feed(struct dvb_demux_feed *dvbdmxfeed)
__func__, __LINE__, stdemux, channel->tsin_id);
/* turn off all PIDS in the bitmap */
- memset((void *)channel->pid_buffer_aligned
- , 0x00, PID_TABLE_SIZE);
+ memset(channel->pid_buffer_aligned, 0, PID_TABLE_SIZE);
/* manage cache so data is visible to HW */
dma_sync_single_for_device(fei->dev,
@@ -458,23 +457,19 @@ static int configure_memdma_and_inputblock(struct c8sectpfei *fei,
init_completion(&tsin->idle_completion);
- tsin->back_buffer_start = kzalloc(FEI_BUFFER_SIZE +
- FEI_ALIGNMENT, GFP_KERNEL);
-
+ tsin->back_buffer_start = kzalloc(FEI_BUFFER_SIZE + FEI_ALIGNMENT, GFP_KERNEL);
if (!tsin->back_buffer_start) {
ret = -ENOMEM;
goto err_unmap;
}
/* Ensure backbuffer is 32byte aligned */
- tsin->back_buffer_aligned = tsin->back_buffer_start
- + FEI_ALIGNMENT;
+ tsin->back_buffer_aligned = tsin->back_buffer_start + FEI_ALIGNMENT;
- tsin->back_buffer_aligned = (void *)
- (((uintptr_t) tsin->back_buffer_aligned) & ~0x1F);
+ tsin->back_buffer_aligned = PTR_ALIGN(tsin->back_buffer_aligned, FEI_ALIGNMENT);
tsin->back_buffer_busaddr = dma_map_single(fei->dev,
- (void *)tsin->back_buffer_aligned,
+ tsin->back_buffer_aligned,
FEI_BUFFER_SIZE,
DMA_BIDIRECTIONAL);
@@ -489,8 +484,7 @@ static int configure_memdma_and_inputblock(struct c8sectpfei *fei,
* per pid. By powers of deduction we conclude stih407 family
* is configured (at SoC design stage) for bit per pid.
*/
- tsin->pid_buffer_start = kzalloc(2048, GFP_KERNEL);
-
+ tsin->pid_buffer_start = kzalloc(PID_TABLE_SIZE + PID_TABLE_SIZE, GFP_KERNEL);
if (!tsin->pid_buffer_start) {
ret = -ENOMEM;
goto err_unmap;
@@ -503,11 +497,9 @@ static int configure_memdma_and_inputblock(struct c8sectpfei *fei,
* the register.
*/
- tsin->pid_buffer_aligned = tsin->pid_buffer_start +
- PID_TABLE_SIZE;
+ tsin->pid_buffer_aligned = tsin->pid_buffer_start + PID_TABLE_SIZE;
- tsin->pid_buffer_aligned = (void *)
- (((uintptr_t) tsin->pid_buffer_aligned) & ~0x3ff);
+ tsin->pid_buffer_aligned = PTR_ALIGN(tsin->pid_buffer_aligned, PID_TABLE_SIZE);
tsin->pid_buffer_busaddr = dma_map_single(fei->dev,
tsin->pid_buffer_aligned,
There are a few cases where code is harder than needed to read. Improve those by: - dropping unnecessary castings (see note below) - use PTR_ALING() to be more explicit on what's going on there - use proper definitions instead of hard coded values Note, dropping castings will allow to perform an additional check that type is not changed from void * to something else, e.g. u64, which may very well break the bitmap APIs. Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com> --- .../platform/sti/c8sectpfe/c8sectpfe-core.c | 30 +++++++------------ 1 file changed, 11 insertions(+), 19 deletions(-)