diff mbox

ARM: ux500: Assign proper sensore IRQs for Snowball

Message ID 1446715379-4374-1-git-send-email-linus.walleij@linaro.org
State Accepted
Commit c80b4010d7e4a1ba2aa83928a659f4bd87c1019c
Headers show

Commit Message

Linus Walleij Nov. 5, 2015, 9:22 a.m. UTC 
The Snowball gyro and magnetometer DRDY (data ready) lines are used
as interrupt triggers by the IIO subsystem, triggering new data
retrieveal on edges on this signal. Thus assign them as the primary
interrupt in the device tree. The "other interrupt" coming out of
the sensors is for alarms and similar complex events, the DRDY is
for periodic measures, which is what we want.

After this the generic_buffer tool from IIO tools gives a nice
stream of readings after enabling the desired channels in sysfs.

Cc: Denis Ciocca <denis.ciocca@st.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

---
 arch/arm/boot/dts/ste-snowball.dts | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

-- 
2.4.3


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
diff mbox

Patch

diff --git a/arch/arm/boot/dts/ste-snowball.dts b/arch/arm/boot/dts/ste-snowball.dts
index e80e42163883..08f82077b64d 100644
--- a/arch/arm/boot/dts/ste-snowball.dts
+++ b/arch/arm/boot/dts/ste-snowball.dts
@@ -281,7 +281,8 @@ 
 				vddio-supply = <&db8500_vsmps2_reg>;
 				pinctrl-names = "default";
 				pinctrl-0 = <&magneto_snowball_mode>;
-				gpios = <&gpio5 5 0x4>; /* DRDY line */
+				interrupt-parent = <&gpio5>;
+				interrupts = <5 IRQ_TYPE_EDGE_RISING>; /* DRDY line */
 			};
 			l3g4200d@68 {
 				/* Gyroscope */
@@ -292,9 +293,9 @@ 
 				vddio-supply = <&db8500_vsmps2_reg>;
 				pinctrl-names = "default";
 				pinctrl-0 = <&gyro_snowball_mode>;
-				gpios = <&gpio5 6 0x4>; /* DRDY line */
 				interrupt-parent = <&gpio5>;
-				interrupts = <9 IRQ_TYPE_EDGE_RISING>; /* INT1 */
+				interrupts = <6 IRQ_TYPE_EDGE_RISING>, /* DRDY line */
+					     <9 IRQ_TYPE_EDGE_RISING>; /* INT1 */
 			};
 			lsp001wm@5c {
 				/* Barometer/pressure sensor */