diff mbox series

[RFC,v3,net-next,04/10] dt-bindings: net: dsa: microchip: add missing CPU port phy-mode to example

Message ID 20220806141059.2498226-5-vladimir.oltean@nxp.com
State Accepted
Commit 2401bd9532fe750974e4ff45fdad954f6f7dc694
Headers show
Series Validate OF nodes for DSA shared ports | expand

Commit Message

Vladimir Oltean Aug. 6, 2022, 2:10 p.m. UTC 
The ksz_switch_chips[] element for KSZ9477 says that port 5 is an xMII
port and it supports speeds of 10/100/1000. The device tree example does
declare a fixed-link at 1000, and RGMII is the only one of those modes
that supports this speed, so use this phy-mode.

The microchip,ksz8565 compatible string is not supported by the
microchip driver, however on Microchip's product page it says that there
are 5 ports, 4 of which have internal PHYs and the 5th is an
MII/RMII/RGMII port. It's a bit strange that this is port@6, but it is
probably just the way it is. Select an RGMII phy-mode for this one as
well.

Signed-off-by: Vladimir Oltean <vladimir.oltean@nxp.com>
---
v2->v3: patch is new

 Documentation/devicetree/bindings/net/dsa/microchip,ksz.yaml | 4 ++++
 1 file changed, 4 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/net/dsa/microchip,ksz.yaml b/Documentation/devicetree/bindings/net/dsa/microchip,ksz.yaml
index 6bbd8145b6c1..456802affc9d 100644
--- a/Documentation/devicetree/bindings/net/dsa/microchip,ksz.yaml
+++ b/Documentation/devicetree/bindings/net/dsa/microchip,ksz.yaml
@@ -109,6 +109,8 @@  examples:
                     reg = <5>;
                     label = "cpu";
                     ethernet = <&eth0>;
+                    phy-mode = "rgmii";
+
                     fixed-link {
                         speed = <1000>;
                         full-duplex;
@@ -146,6 +148,8 @@  examples:
                     reg = <6>;
                     label = "cpu";
                     ethernet = <&eth0>;
+                    phy-mode = "rgmii";
+
                     fixed-link {
                         speed = <1000>;
                         full-duplex;