@@ -893,6 +893,10 @@
gpmc,num-waitpins = <2>;
#address-cells = <2>;
#size-cells = <1>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
status = "disabled";
};
@@ -146,10 +146,13 @@
pinctrl-0 = <&nand_flash_x8>;
ranges = <0 0 0x08000000 0x1000000>;
nand@0,0 {
- reg = <0 0 0>;
+ compatible = "ti,omap2-nand";
+ reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
+ <1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch8";
ti,elm-id = <&elm>;
-
nand-bus-width = <8>;
gpmc,device-width = <1>;
gpmc,sync-clk-ps = <0>;
@@ -812,9 +812,13 @@
status = "okay";
pinctrl-names = "default";
pinctrl-0 = <&nand_flash_x8>;
- ranges = <0 0 0 0x01000000>; /* minimum GPMC partition = 16MB */
+ ranges = <0 0 0x08000000 0x01000000>; /* CS0 space. Min partition = 16MB */
nand@0,0 {
+ compatible = "ti,omap2-nand";
reg = <0 0 4>; /* device IO registers */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
+ <1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch16";
ti,elm-id = <&elm>;
nand-bus-width = <8>;
@@ -561,9 +561,13 @@
status = "okay"; /* Disable QSPI when enabling GPMC (NAND) */
pinctrl-names = "default";
pinctrl-0 = <&nand_flash_x8>;
- ranges = <0 0 0x08000000 0x1000000>; /* CS0: 16MB for NAND */
+ ranges = <0 0 0x08000000 0x01000000>; /* CS0 space. Min partition = 16MB */
nand@0,0 {
+ compatible = "ti,omap2-nand";
reg = <0 0 4>; /* CS0, offset 0, IO size 4 */
+ interrupt-parent = <&gpmc>;
+ interrupts = <0 IRQ_TYPE_NONE>, /* fifoevent */
+ <1 IRQ_TYPE_NONE>; /* termcount */
ti,nand-ecc-opt = "bch16";
ti,elm-id = <&elm>;
nand-bus-width = <8>;
Add compatible id, GPMC register resource and interrupt resource to NAND controller nodes. The GPMC driver now implements gpiochip and irqchip so enable gpio-controller and interrupt-controller properties. With this the interrupt parent of NAND node changes so fix it accordingly. Signed-off-by: Roger Quadros <rogerq@ti.com> --- arch/arm/boot/dts/am4372.dtsi | 4 ++++ arch/arm/boot/dts/am437x-cm-t43.dts | 7 +++++-- arch/arm/boot/dts/am437x-gp-evm.dts | 6 +++++- arch/arm/boot/dts/am43x-epos-evm.dts | 6 +++++- 4 files changed, 19 insertions(+), 4 deletions(-) -- 2.1.4