@@ -386,40 +386,28 @@ ENTRY(secondary_startup)
/*
* Use the page tables supplied from __cpu_up.
*/
- adr r4, __secondary_data
- ldmia r4, {r5, r7, r12} @ address to jump to after
- sub lr, r4, r5 @ mmu has been enabled
- add r3, r7, lr
+ adr_l r3, secondary_data
ldrd r4, [r3, #0] @ get secondary_data.pgdir
ARM_BE8(eor r4, r4, r5) @ Swap r5 and r4 in BE:
ARM_BE8(eor r5, r4, r5) @ it can be done in 3 steps
ARM_BE8(eor r4, r4, r5) @ without using a temp reg.
ldr r8, [r3, #8] @ get secondary_data.swapper_pg_dir
badr lr, __enable_mmu @ return address
- mov r13, r12 @ __secondary_switched address
+ ldr r13, =__secondary_switched @ __secondary_switched address
ldr r12, [r10, #PROCINFO_INITFUNC]
add r12, r12, r10 @ initialise processor
@ (return control reg)
ret r12
ENDPROC(secondary_startup)
ENDPROC(secondary_startup_arm)
+ .ltorg
- /*
- * r6 = &secondary_data
- */
ENTRY(__secondary_switched)
- ldr sp, [r7, #12] @ get secondary_data.stack
+ ldr_l sp, secondary_data + 12, ip @ get secondary_data.stack
mov fp, #0
b secondary_start_kernel
ENDPROC(__secondary_switched)
- .align
-
- .type __secondary_data, %object
-__secondary_data:
- .long .
- .long secondary_data
- .long __secondary_switched
#endif /* defined(CONFIG_SMP) */
Replace the open coded PC relative offset calculations with adr_l and ldr_l invocations. Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org> --- arch/arm/kernel/head.S | 20 ++++---------------- 1 file changed, 4 insertions(+), 16 deletions(-) -- 2.7.4 _______________________________________________ linux-arm-kernel mailing list linux-arm-kernel@lists.infradead.org http://lists.infradead.org/mailman/listinfo/linux-arm-kernel