@@ -82,13 +82,12 @@
#define START_RW_READ 1
/**
- * START_BYTE(id, rs, rw)
- *
- * Set the start byte according to the required operation.
+ * START_BYTE() - Set the start byte according to the required operation.
* The start byte is defined as:
* ----------------------------------
* | 0 | 1 | 1 | 1 | 0 | ID | RS | RW |
* ----------------------------------
+ *
* @id: display's id as set by the manufacturer
* @rs: operation type bit, one of:
* - START_RS_INDEX set the index register
@@ -101,14 +100,14 @@
(0x70 | (((id) & 0x01) << 2) | (((rs) & 0x01) << 1) | ((rw) & 0x01))
/**
- * CHECK_FREQ_REG(spi_device s, spi_transfer x) - Check the frequency
+ * CHECK_FREQ_REG() - Check the frequency
* for the SPI transfer. According to the datasheet, the controller
* accept higher frequency for the GRAM transfer, but it requires
* lower frequency when the registers are read/written.
* The macro sets the frequency in the spi_transfer structure if
* the frequency exceeds the maximum value.
* @s: pointer to an SPI device
- * @x: pointer to the read/write buffer pair
+ * @x: pointer to the &spi_transfer read/write buffer pair
*/
#define CHECK_FREQ_REG(s, x) \
do { \
Fix kernel-doc warnings found when using "W=1". ili922x.c:85: warning: This comment starts with '/**', but isn't a kernel-doc comment. Refer Documentation/doc-guide/kernel-doc.rst ili922x.c:85: warning: missing initial short description on line: * START_BYTE(id, rs, rw) ili922x.c:91: warning: contents before sections ili922x.c:118: warning: expecting prototype for CHECK_FREQ_REG(spi_device s, spi_transfer x)(). Prototype was for CHECK_FREQ_REG() instead Signed-off-by: Randy Dunlap <rdunlap@infradead.org> Cc: Lee Jones <lee@kernel.org> Cc: Daniel Thompson <daniel.thompson@linaro.org> Cc: Jingoo Han <jingoohan1@gmail.com> Cc: Helge Deller <deller@gmx.de> Cc: linux-fbdev@vger.kernel.org --- drivers/video/backlight/ili922x.c | 9 ++++----- 1 file changed, 4 insertions(+), 5 deletions(-)