diff mbox series

[v1,1/1] gpio: nomadik: Finish conversion to use firmware node APIs

Message ID 20240301225819.193814-1-andy.shevchenko@gmail.com
State New
Headers show
Series [v1,1/1] gpio: nomadik: Finish conversion to use firmware node APIs | expand

Commit Message

Andy Shevchenko March 1, 2024, 10:58 p.m. UTC
Previously driver got a few updates in order to replace OF APIs by
respective firmware node, however it was not finished to the logical
end, e.g., some APIs that has been used are still require OF node
to be passed. Finish that job by converting leftovers to use firmware
node APIs.

Signed-off-by: Andy Shevchenko <andy.shevchenko@gmail.com>
---
 drivers/gpio/Kconfig        |  1 -
 drivers/gpio/gpio-nomadik.c | 13 ++++++-------
 2 files changed, 6 insertions(+), 8 deletions(-)

Comments

Andy Shevchenko March 1, 2024, 11:07 p.m. UTC | #1
Sat, Mar 02, 2024 at 12:58:19AM +0200, andy.shevchenko@gmail.com kirjoitti:
> Previously driver got a few updates in order to replace OF APIs by
> respective firmware node, however it was not finished to the logical
> end, e.g., some APIs that has been used are still require OF node
> to be passed. Finish that job by converting leftovers to use firmware
> node APIs.

It misses changes in the pinctrl.
diff mbox series

Patch

diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index f633be517654..ef20ab921010 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -481,7 +481,6 @@  config GPIO_MXS
 config GPIO_NOMADIK
 	bool "Nomadik GPIO driver"
 	depends on ARCH_U8500 || ARCH_NOMADIK || MACH_EYEQ5 || COMPILE_TEST
-	depends on OF_GPIO
 	select GPIOLIB_IRQCHIP
 	help
 	  Say yes here to support the Nomadik SoC GPIO block. This block is also
diff --git a/drivers/gpio/gpio-nomadik.c b/drivers/gpio/gpio-nomadik.c
index c9fd6631e0aa..483086deb397 100644
--- a/drivers/gpio/gpio-nomadik.c
+++ b/drivers/gpio/gpio-nomadik.c
@@ -23,10 +23,10 @@ 
 #include <linux/gpio/driver.h>
 #include <linux/interrupt.h>
 #include <linux/kernel.h>
-#include <linux/of_device.h>
-#include <linux/of_platform.h>
+#include <linux/mod_devicetable.h>
 #include <linux/pinctrl/pinctrl.h>
 #include <linux/platform_device.h>
+#include <linux/property.h>
 #include <linux/reset.h>
 #include <linux/seq_file.h>
 #include <linux/slab.h>
@@ -504,7 +504,7 @@  static inline void nmk_gpio_dbg_show_one(struct seq_file *s,
  * it is the pin controller or GPIO driver. However we need to use the right
  * platform device when looking up resources so pay attention to pdev.
  */
-struct nmk_gpio_chip *nmk_gpio_populate_chip(struct device_node *np,
+struct nmk_gpio_chip *nmk_gpio_populate_chip(struct fwnode_handle *fwnode,
 					     struct platform_device *pdev)
 {
 	struct nmk_gpio_chip *nmk_chip;
@@ -517,9 +517,9 @@  struct nmk_gpio_chip *nmk_gpio_populate_chip(struct device_node *np,
 	u32 id, ngpio;
 	int ret;
 
-	gpio_dev = bus_find_device_by_of_node(&platform_bus_type, np);
+	gpio_dev = bus_find_device_by_fwnode(&platform_bus_type, fwnode);
 	if (!gpio_dev) {
-		pr_err("populate \"%pOFn\": device not found\n", np);
+		dev_err(&pdev->dev, "populate \"%pfwP\": device not found\n", fwnode);
 		return ERR_PTR(-ENODEV);
 	}
 	gpio_pdev = to_platform_device(gpio_dev);
@@ -624,7 +624,6 @@  static const struct irq_chip nmk_irq_chip = {
 static int nmk_gpio_probe(struct platform_device *pdev)
 {
 	struct device *dev = &pdev->dev;
-	struct device_node *np = dev->of_node;
 	struct nmk_gpio_chip *nmk_chip;
 	struct gpio_irq_chip *girq;
 	bool supports_sleepmode;
@@ -632,7 +631,7 @@  static int nmk_gpio_probe(struct platform_device *pdev)
 	int irq;
 	int ret;
 
-	nmk_chip = nmk_gpio_populate_chip(np, pdev);
+	nmk_chip = nmk_gpio_populate_chip(dev_fwnode(dev), pdev);
 	if (IS_ERR(nmk_chip)) {
 		dev_err(dev, "could not populate nmk chip struct\n");
 		return PTR_ERR(nmk_chip);