new file mode 100644
@@ -0,0 +1,80 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/sound/nuvoton,nau8325.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: NAU8325 audio Amplifier
+
+maintainers:
+ - Seven Lee <WTLI@nuvoton.com>
+
+allOf:
+ - $ref: dai-common.yaml#
+
+properties:
+ compatible:
+ const: nuvoton,nau8325
+
+ reg:
+ maxItems: 1
+
+ nuvoton,vref-impedance-ohms:
+ description:
+ The vref impedance to be used in ohms. Middle of voltage enables
+ Tie-Off selection options. Due to the high impedance of the VREF
+ pin, it is important to use a low-leakage capacitor.
+
+ enum: [0, 25000, 125000, 2500]
+
+ nuvoton,dac-vref-microvolt:
+ description:
+ The DAC vref to be used in voltage. DAC reference voltage setting. Can
+ be used for minor tuning of the output level. Since the VDDA is range
+ between 1.62 to 1.98 voltage, the typical value for design is 1.8V. After
+ the minor tuning, the final microvolt are as the below.
+
+ enum: [1800000, 2700000, 2880000, 3060000]
+
+ nuvoton,alc-enable:
+ description:
+ Enable digital automatic level control (ALC) function.
+ type: boolean
+
+ nuvoton,clock-detection-disable:
+ description:
+ When clock detection is enabled, it will detect whether MCLK
+ and FS are within the range. MCLK range is from 2.048MHz to 24.576MHz.
+ FS range is from 8kHz to 96kHz. And also needs to detect the ratio
+ MCLK_SRC/LRCK of 256, 400 or 500, and needs to detect the BCLK
+ to make sure data is present. There needs to be at least 8 BCLK
+ cycles per Frame Sync.
+ type: boolean
+
+ nuvoton,clock-det-data:
+ description:
+ Request clock detection to require 2048 non-zero samples before enabling
+ the audio paths. If set then non-zero samples is required, otherwise it
+ doesn't matter.
+ type: boolean
+
+required:
+ - compatible
+ - reg
+
+unevaluatedProperties: false
+
+examples:
+ - |
+ i2c {
+ #address-cells = <1>;
+ #size-cells = <0>;
+ codec@21 {
+ compatible = "nuvoton,nau8325";
+ reg = <0x21>;
+ nuvoton,vref-impedance-ohms = <125000>;
+ nuvoton,dac-vref-microvolt = <2880000>;
+ nuvoton,alc-enable;
+ nuvoton,clock-det-data;
+ };
+ };
Add a DT schema for describing nau8325 audio amplifiers. The key features are as follows: - Low SPK_VDD Quiescent Current - Gain Setting with 2-wire interface - Powerful Stereo Class-D Amplifier - Low Output Noise - Low Current Shutdown Mode - Click-and Pop Suppression More resources : https://www.nuvoton.com/products/smart-home-audio/audio-amplifiers/class-d-series/nau8325yg/ Signed-off-by: Seven Lee <wtli@nuvoton.com> --- .../bindings/sound/nuvoton,nau8325.yaml | 80 +++++++++++++++++++ 1 file changed, 80 insertions(+) create mode 100644 Documentation/devicetree/bindings/sound/nuvoton,nau8325.yaml