@@ -1510,8 +1510,8 @@ static int cqspi_of_get_pdata(struct cqspi_st *cqspi)
cqspi->is_decoded_cs = of_property_read_bool(np, "cdns,is-decoded-cs");
if (of_property_read_u32(np, "cdns,fifo-depth", &cqspi->fifo_depth)) {
- dev_err(dev, "couldn't determine fifo-depth\n");
- return -ENXIO;
+ /* Zero signals FIFO depth should be runtime detected. */
+ cqspi->fifo_depth = 0;
}
if (of_property_read_u32(np, "cdns,fifo-width", &cqspi->fifo_width)) {
@@ -1541,8 +1541,6 @@ static void cqspi_controller_init(struct cqspi_st *cqspi)
{
u32 reg;
- cqspi_controller_enable(cqspi, 0);
-
/* Configure the remap address register, no remap */
writel(0, cqspi->iobase + CQSPI_REG_REMAP);
@@ -1576,8 +1574,29 @@ static void cqspi_controller_init(struct cqspi_st *cqspi)
reg |= CQSPI_REG_CONFIG_DMA_MASK;
writel(reg, cqspi->iobase + CQSPI_REG_CONFIG);
}
+}
- cqspi_controller_enable(cqspi, 1);
+static void cqspi_controller_detect_fifo_depth(struct cqspi_st *cqspi)
+{
+ struct device *dev = &cqspi->pdev->dev;
+ u32 reg, fifo_depth;
+
+ /*
+ * Bits N-1:0 are writable while bits 31:N are read as zero, with 2^N
+ * the FIFO depth.
+ */
+ writel(U32_MAX, cqspi->iobase + CQSPI_REG_SRAMPARTITION);
+ reg = readl(cqspi->iobase + CQSPI_REG_SRAMPARTITION);
+ fifo_depth = reg + 1;
+
+ /* FIFO depth of zero means no value from devicetree was provided. */
+ if (cqspi->fifo_depth == 0) {
+ cqspi->fifo_depth = fifo_depth;
+ dev_dbg(dev, "using FIFO depth of %u\n", fifo_depth);
+ } else if (fifo_depth != cqspi->fifo_depth) {
+ dev_warn(dev, "detected FIFO depth (%u) different from config (%u)\n",
+ fifo_depth, cqspi->fifo_depth);
+ }
}
static int cqspi_request_mmap_dma(struct cqspi_st *cqspi)
@@ -1730,6 +1749,7 @@ static int cqspi_probe(struct platform_device *pdev)
cqspi->pdev = pdev;
cqspi->host = host;
cqspi->is_jh7110 = false;
+ cqspi->ddata = ddata = of_device_get_match_data(dev);
platform_set_drvdata(pdev, cqspi);
/* Obtain configuration from OF. */
@@ -1821,8 +1841,6 @@ static int cqspi_probe(struct platform_device *pdev)
/* write completion is supported by default */
cqspi->wr_completion = true;
- ddata = of_device_get_match_data(dev);
- cqspi->ddata = ddata;
if (ddata) {
if (ddata->quirks & CQSPI_NEEDS_WR_DELAY)
cqspi->wr_delay = 50 * DIV_ROUND_UP(NSEC_PER_SEC,
@@ -1864,7 +1882,10 @@ static int cqspi_probe(struct platform_device *pdev)
}
cqspi_wait_idle(cqspi);
+ cqspi_controller_enable(cqspi, 0);
+ cqspi_controller_detect_fifo_depth(cqspi);
cqspi_controller_init(cqspi);
+ cqspi_controller_enable(cqspi, 1);
cqspi->current_cs = -1;
cqspi->sclk = 0;
@@ -1947,7 +1968,9 @@ static int cqspi_runtime_resume(struct device *dev)
clk_prepare_enable(cqspi->clk);
cqspi_wait_idle(cqspi);
+ cqspi_controller_enable(cqspi, 0);
cqspi_controller_init(cqspi);
+ cqspi_controller_enable(cqspi, 1);
cqspi->current_cs = -1;
cqspi->sclk = 0;
If FIFO depth DT property is provided, check it matches what hardware reports and warn otherwise. Else, use hardware provided value. Hardware exposes FIFO depth indirectly because CQSPI_REG_SRAMPARTITION is partially read-only. Move probe cqspi->ddata assignment prior to cqspi_of_get_pdata() call. Signed-off-by: Théo Lebrun <theo.lebrun@bootlin.com> --- drivers/spi/spi-cadence-quadspi.c | 37 ++++++++++++++++++++++++++++++------- 1 file changed, 30 insertions(+), 7 deletions(-)