@@ -168,6 +168,7 @@ enum i2c_type_exynos {
I2C_TYPE_EXYNOS5,
I2C_TYPE_EXYNOS7,
I2C_TYPE_EXYNOSAUTOV9,
+ I2C_TYPE_EXYNOS8895,
};
struct exynos5_i2c {
@@ -240,6 +241,11 @@ static const struct exynos_hsi2c_variant exynosautov9_hsi2c_data = {
.hw = I2C_TYPE_EXYNOSAUTOV9,
};
+static const struct exynos_hsi2c_variant exynos8895_hsi2c_data = {
+ .fifo_depth = 64,
+ .hw = I2C_TYPE_EXYNOS8895,
+};
+
static const struct of_device_id exynos5_i2c_match[] = {
{
.compatible = "samsung,exynos5-hsi2c",
@@ -256,6 +262,9 @@ static const struct of_device_id exynos5_i2c_match[] = {
}, {
.compatible = "samsung,exynosautov9-hsi2c",
.data = &exynosautov9_hsi2c_data
+ }, {
+ .compatible = "samsung,exynos8895-hsi2c",
+ .data = &exynos8895_hsi2c_data
}, {},
};
MODULE_DEVICE_TABLE(of, exynos5_i2c_match);
@@ -331,6 +340,14 @@ static int exynos5_i2c_set_timing(struct exynos5_i2c *i2c, bool hs_timings)
* clk_cycle := TSCLK_L + TSCLK_H
* temp := (CLK_DIV + 1) * (clk_cycle + 2)
*
+ * In case of HSI2C controllers in Exynos8895
+ * FPCLK / FI2C =
+ * (CLK_DIV + 1) * (TSCLK_L + TSCLK_H + 2) +
+ * 2 * ((FLT_CYCLE + 3) - (FLT_CYCLE + 3) % (CLK_DIV + 1))
+ *
+ * clk_cycle := TSCLK_L + TSCLK_H
+ * temp := (FPCLK / FI2C) - (FLT_CYCLE + 3) * 2
+ *
* Constraints: 4 <= temp, 0 <= CLK_DIV < 256, 2 <= clk_cycle <= 510
*
* To split SCL clock into low, high periods appropriately, one
@@ -352,11 +369,19 @@ static int exynos5_i2c_set_timing(struct exynos5_i2c *i2c, bool hs_timings)
*
*/
t_ftl_cycle = (readl(i2c->regs + HSI2C_CONF) >> 16) & 0x7;
- temp = clkin / op_clk - 8 - t_ftl_cycle;
+ if (i2c->variant->hw == I2C_TYPE_EXYNOS8895)
+ temp = clkin / op_clk - (t_ftl_cycle + 3) * 2;
+ else
+ temp = clkin / op_clk - 8 - t_ftl_cycle;
if (i2c->variant->hw != I2C_TYPE_EXYNOS7)
temp -= t_ftl_cycle;
div = temp / 512;
- clk_cycle = temp / (div + 1) - 2;
+
+ if (i2c->variant->hw == I2C_TYPE_EXYNOS8895)
+ clk_cycle = (temp + ((t_ftl_cycle + 3) % (div + 1)) * 2) /
+ (div + 1) - 2;
+ else
+ clk_cycle = temp / (div + 1) - 2;
if (temp < 4 || div >= 256 || clk_cycle < 2) {
dev_err(i2c->dev, "%s clock set-up failed\n",
hs_timings ? "HS" : "FS");
@@ -491,6 +516,8 @@ static irqreturn_t exynos5_i2c_irq(int irqno, void *dev_id)
switch (i2c->variant->hw) {
case I2C_TYPE_EXYNOSAUTOV9:
fallthrough;
+ case I2C_TYPE_EXYNOS8895:
+ fallthrough;
case I2C_TYPE_EXYNOS7:
if (int_status & HSI2C_INT_TRANS_DONE) {
i2c->trans_done = 1;
Exynos8895 functioning logic mostly follows I2C_TYPE_EXYNOS7, but timing and temp calculations are slightly changed according to the following logic: FPCLK / FI2C = (CLK_DIV + 1) * (TSCLK_L + TSCLK_H + 2) + 2 * ((FLT_CYCLE + 3) - (FLT_CYCLE + 3) % (CLK_DIV + 1)) temp := (FPCLK / FI2C) - (FLT_CYCLE + 3) * 2 Signed-off-by: Ivaylo Ivanov <ivo.ivanov.ivanov1@gmail.com> --- drivers/i2c/busses/i2c-exynos5.c | 31 +++++++++++++++++++++++++++++-- 1 file changed, 29 insertions(+), 2 deletions(-)