@@ -78,6 +78,15 @@
#define MAX96717_GPIO_TX_EN BIT(1)
#define MAX96717_GPIO_OUT_DIS BIT(0)
+/* CMU */
+#define MAX96717_CMU_CMU2 CCI_REG8(0x0302)
+#define MAX96717_PFDDIV_RSHORT_MASK GENMASK(6, 4)
+#define MAX96717_PFDDIV_RSHORT_SHIFT 4
+#define MAX96717_PFDDIV_VREG_1V0 0
+#define MAX96717_PFDDIV_VREG_1V1 1
+#define MAX96717_PFDDIV_VREG_0V875 2
+#define MAX96717_PFDDIV_VREG_0V94 3
+
/* FRONTTOP */
/* MAX96717 only have CSI port 'B' */
#define MAX96717_FRONTOP0 CCI_REG8(0x308)
@@ -981,6 +990,14 @@ static int max96717_hw_init(struct max96717_priv *priv)
dev_dbg(dev, "Found %x (rev %lx)\n", (u8)dev_id,
(u8)val & MAX96717_DEV_REV_MASK);
+ /*
+ * According to specs, in the Programming Notes section, there's a mandatory register
+ * programming notice that advises to enable the 1.1V internal regulator to guarantee proper
+ * device operation. Let's do this before any other operations.
+ */
+ cci_write(priv->regmap, MAX96717_CMU_CMU2,
+ MAX96717_PFDDIV_VREG_1V1 << MAX96717_PFDDIV_RSHORT_SHIFT, NULL);
+
ret = cci_read(priv->regmap, MAX96717_MIPI_RX_EXT11, &val, NULL);
if (ret)
return dev_err_probe(dev, ret,
The Programming Notes section of the specifications states: """ MANDATORY REGISTER PROGRAMMING Make the following register writes to ensure proper operation of the MAX96717F. Without these writes, the operation of the device specified in the data sheet cannot be guaranteed. Set bits [6:4] = 3'b001 in register 0x302 """ Set this register before going on with the chip initialization. Signed-off-by: Laurentiu Palcu <laurentiu.palcu@oss.nxp.com> --- drivers/media/i2c/max96717.c | 17 +++++++++++++++++ 1 file changed, 17 insertions(+)