| Message ID | 20250422162250.436169-4-uwu@icenowy.me |
|---|---|
| State | New |
| Headers | show |
| Series | pinctrl: starfive: jh7110: support force inputs | expand |
diff --git a/arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts b/arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts index 31e825be2065a..dab0e0054e648 100644 --- a/arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts +++ b/arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts @@ -81,6 +81,8 @@ &spi0 { }; &sysgpio { + starfive,force-high-inputs = <GPI_SYS_USB_OVERCURRENT>; + usb0_pins: usb0-0 { vbus-pins { pinmux = <GPIOMUX(25, GPOUT_SYS_USB_DRIVE_VBUS,
The Star64 board has no GPIOs to indicate USB overcurrent, however the USB controller would stop to work if the overcurrent_n signal it gets is low (which means overcurrent situations happening because of the _n). Use the pin controller to force the overcurrent_n signal to be high in order to ensure stable behavior of the USB controller. Signed-off-by: Icenowy Zheng <uwu@icenowy.me> --- arch/riscv/boot/dts/starfive/jh7110-pine64-star64.dts | 2 ++ 1 file changed, 2 insertions(+)