Current Team Memberships

Show patches with: none      |   6497 patches
« 1 2 ... 62 63 64 65 »
▾
Patch Series S/W/F Date Submitter Delegate State
[2/2] mmci: fixup sg buffer handling in mmci_pio_irq. --- 2011-05-05 Linus Walleij Not Applicable
[1/2] mmci: trigger card detect IRQs on falling and rising edges --- 2011-05-05 Linus Walleij Accepted
[4/4] pinmux: activate pinmux driver, delete old padmux driver --- 2011-05-02 Linus Walleij Superseded
[3/4] amba: request muxing for PrimeCell devices --- 2011-05-02 Linus Walleij Superseded
[2/4] pinmux: add a driver for the U300 pinmux --- 2011-05-02 Linus Walleij Superseded
[1/4] drivers: create a pinmux subsystem --- 2011-05-02 Linus Walleij Superseded
RFC: mmc: subtract boot sectors from disk size on quirky cards --- 2011-04-28 Linus Walleij Rejected
gpio: remove some legacy comments in build files --- 2011-04-28 Linus Walleij Accepted
gpio: rename VIA local config struct --- 2011-04-28 Linus Walleij Accepted
[10/10] gpio/nomadik-gpio: merge pinconfig API --- 2011-04-27 Linus Walleij Superseded
[09/10] gpio/nomadik-gpio: factor out state cast function --- 2011-04-27 Linus Walleij Superseded
[08/10] gpio/nomadik-gpio: work with all machines --- 2011-04-27 Linus Walleij Superseded
[07/10] gpio: move the Nomadik GPIO driver to drivers/gpio --- 2011-04-27 Linus Walleij Superseded
[06/10] plat-nomadik: disable clocks when unused --- 2011-04-27 Linus Walleij Superseded
[05/10] plat-nomadik: add function to read GPIO pull down status --- 2011-04-27 Linus Walleij Superseded
[04/10] plat-nomadik: gpio show all pins in debug --- 2011-04-27 Linus Walleij Superseded
[03/10] plat-nomadik: remove pull-pinconfig and add SPI2 --- 2011-04-27 Linus Walleij Superseded
[02/10] mach-u300: rewrite gpio driver, move to drivers/gpio --- 2011-04-27 Linus Walleij Superseded
[01/10] gpio: add a custom configuration mechanism to gpiolib --- 2011-04-27 Linus Walleij Superseded
[2/2] mach-u300: rewrite gpio driver, move to drivers/gpio --- 2011-04-20 Linus Walleij Superseded
[1/2] gpio: add a custom configuration mechanism to gpiolib --- 2011-04-20 Linus Walleij Superseded
mmci: sync DATAEND irq with dma transfer done --- 2011-04-19 Linus Walleij Superseded
[2/2] mach-u300: rewrite gpio driver, move to drivers/gpio --- 2011-04-17 Linus Walleij Superseded
[1/2] gpio: add pin biasing and drive mode to gpiolib --- 2011-04-17 Linus Walleij Superseded
rtc: fix coh901331 startup crash --- 2011-04-17 Linus Walleij Accepted
[2/2] mach-ux500: complete regulator constraints for MOP500 board --- 2011-04-04 Linus Walleij Superseded
[1/2] mach-ux500: voltage domain regulators for DB8500 --- 2011-04-04 Linus Walleij Superseded
mach-ux500: split per-SoC clock trees --- 2011-04-01 Linus Walleij Superseded
plat-nomadik: remove pull-pinconfig and add SPI2 --- 2011-04-01 Linus Walleij Accepted
mmci: force negative edge on clock bypass for ux500 --- 2011-03-31 Linus Walleij Accepted
[9/9] mach-ux500: add DB5500 PRCMU interface --- 2011-03-31 Linus Walleij Superseded
[8/9] mach-ux500: new DB8500 PRCMU firmware API --- 2011-03-31 Linus Walleij Superseded
[7/9] mach-ux500: create a PM subdirectory --- 2011-03-31 Linus Walleij Superseded
[6/9] mach-ux500: update ASIC version detection --- 2011-03-31 Linus Walleij Accepted
[5/9] mach-ux500: update SoC and board IRQ handling --- 2011-03-31 Linus Walleij Accepted
[4/9] mach-ux500: update the DB5500 register file --- 2011-03-31 Linus Walleij Accepted
[3/9] mach-ux500: update the DB8500 register file --- 2011-03-31 Linus Walleij Accepted
[2/9] mach-ux500: make PRCMU base address dynamic --- 2011-03-31 Linus Walleij Accepted
[1/9] mach-ux500: rename PRCMU driver per SoC --- 2011-03-31 Linus Walleij Accepted
mach-ux500: add HREFv60 Kconfig option --- 2011-03-31 Linus Walleij Accepted
mach-ux500: correct MMC/SDI parameters --- 2011-03-30 Linus Walleij Accepted
mach-ux500: fix i2c0 device setup regression --- 2011-03-30 Linus Walleij Accepted
[6/6] mmci: support for ST-Ericsson db8500v2 --- 2011-03-23 Linus Walleij Accepted
[5/6] spi/pl022: Add loopback support for the SPI on 5500 --- 2011-03-23 Linus Walleij Superseded
[4/6] mach-ux500: force PrimeCell revisions --- 2011-03-23 Linus Walleij Accepted
[3/6] amba: make hardcoded periphid override hardware --- 2011-03-23 Linus Walleij Accepted
[2/6] mach-ux500: delete SSP PrimeCell ID --- 2011-03-23 Linus Walleij Accepted
[1/6] mach-netx: delete hardcoded periphid --- 2011-03-23 Linus Walleij Accepted
[3/3] regulator: add ab8500 enable and raise time delays --- 2011-03-17 Linus Walleij Accepted
[2/3] regulator: provide consumer interface for fall/rise time --- 2011-03-17 Linus Walleij Accepted
[1/3] regulator: add set_voltage_time_sel infrastructure --- 2011-03-17 Linus Walleij Accepted
[1/4] amba: add name based matching --- 2011-03-17 Linus Walleij Rejected
mfd: rename ab8500 gpadc header --- 2011-03-15 Linus Walleij Accepted
regulator: switch the ab3100 to use enable_time() --- 2011-03-11 Linus Walleij Accepted
[4/4] mach-ux500: provide ab8500 init vector --- 2011-03-11 Linus Walleij Accepted
[3/4] regulator: initialization for ab8500 regulators --- 2011-03-11 Linus Walleij Accepted
[2/4] regulator: add ab8500 enable and raise time delays --- 2011-03-11 Linus Walleij Accepted
[1/4] regulator: add set_voltage_time[_sel] infrastructure --- 2011-03-11 Linus Walleij Accepted
[4/4] mach-ux500: provide ab8500 init vector --- 2011-03-10 Linus Walleij Accepted
[3/4] regulator: added register initialization for ab8500 regulators --- 2011-03-10 Linus Walleij Accepted
[2/4] regulator: add ab8500 per-regulator startup delay --- 2011-03-10 Linus Walleij Accepted
[1/4] regulator: add support for USB voltage regulator --- 2011-03-10 Linus Walleij Accepted
[3/3] mach-ux500: configure board for the TPS61052 regulator v2 --- 2011-03-09 Linus Walleij Accepted
[2/3] regulator: add a subdriver for TI TPS6105x regulator portions v2 --- 2011-03-09 Linus Walleij Accepted
[1/3] mfd: add a core driver for TI TPS61050/TPS61052 chips v2 --- 2011-03-09 Linus Walleij Accepted
mmc: export function mmc_do_release_host --- 2011-03-09 Linus Walleij Accepted
plat-nomadik: make GPIO interrupts work with cpuidle ApSleep --- 2011-03-08 Linus Walleij Accepted
[3/3] mach-ux500: configure board for the TPS61052 regulator --- 2011-03-08 Linus Walleij Accepted
[2/3] regulator: add a subdriver for TI TPS6105x regulator portions --- 2011-03-08 Linus Walleij Accepted
[1/3] mfd: add a core driver for TI TPS61050/TPS61052 chips --- 2011-03-08 Linus Walleij Accepted
mmc: reset card voltage after power off --- 2011-03-05 Linus Walleij Accepted
mmc: export function mmc_do_release_host --- 2011-03-05 Linus Walleij Superseded
mmc: subtract boot sectors from disk size for eMMC 4.3+ devices --- 2011-03-05 Linus Walleij Rejected
[5/5] mfd: fix ab8500-gpadc to measure charger current --- 2011-03-05 Linus Walleij Accepted
[4/5] mfd: calibrate ab8500 gpadc using OTP values --- 2011-03-05 Linus Walleij Accepted
[3/5] mfd: free dangling irq in ab8500 gpadc probe error path --- 2011-03-05 Linus Walleij Accepted
[2/5] mfd: reentrance and revamp ab8500 gpadc fetching interface --- 2011-03-05 Linus Walleij Accepted
[1/5] mfd: move ab8500 gpadc header to subdir --- 2011-03-05 Linus Walleij Accepted
ARM: fix compile error in tlb.h --- 2011-03-04 Linus Walleij Accepted
msm_sdcc: remove needless cache flush after dma_unmap_sg() --- 2011-03-04 Linus Walleij Accepted
[11/11] tmio_mmc: use dmaengine helpers, drop submit check --- 2011-03-04 Linus Walleij Accepted
[10/11] tmio_mmc: drop dma_sglen state variable --- 2011-03-04 Linus Walleij Accepted
[09/11] tmio_mmc: unmap with the proper sglen --- 2011-03-04 Linus Walleij Accepted
[08/11] tmio_mmc: map DMA buffers on the DMA engine device --- 2011-03-04 Linus Walleij Accepted
[07/11] sh_mmcif: use dmaengine helpers, drop submit check --- 2011-03-04 Linus Walleij Accepted
[06/11] sh_mmcif: rename and retype activity variable --- 2011-03-04 Linus Walleij Accepted
[05/11] sh_mmcif: unmap with the proper sglen --- 2011-03-04 Linus Walleij Accepted
[04/11] sh_mmcif: map DMA buffers on the DMA engine device --- 2011-03-04 Linus Walleij Accepted
[03/11] atmel-mci: use dmaengine helper functions --- 2011-03-04 Linus Walleij Accepted
[02/11] atmel-mci: conform to DMA-API --- 2011-03-04 Linus Walleij Accepted
[01/11] atmel-mci: map DMA sglist on the DMA engine --- 2011-03-04 Linus Walleij Accepted
mmci: separate out ST Micro register defines --- 2011-03-04 Linus Walleij Accepted
mach-ux500: activate USB in the U8500 defconfig --- 2011-03-01 Linus Walleij Accepted
mmc/sdio: remember new card RCA when redetecting card --- 2011-03-01 Linus Walleij Accepted
mach-ux500: activate fix for errata 753970 --- 2011-03-01 Linus Walleij Accepted
Added handling for hangup, hold and conference --- 2009-11-03 Linus Walleij Rejected
Added intents for hangup, hold and conference --- 2009-11-03 Linus Walleij Rejected
« 1 2 ... 62 63 64 65 »

Bundling

Create bundle: