@@ -39,6 +39,8 @@ static const struct i2c_device_id pcm512x_i2c_id[] = {
{ "pcm5122", },
{ "pcm5141", },
{ "pcm5142", },
+ { "tas5754", },
+ { "tas5756", },
{ }
};
MODULE_DEVICE_TABLE(i2c, pcm512x_i2c_id);
@@ -49,6 +51,8 @@ static const struct of_device_id pcm512x_of_match[] = {
{ .compatible = "ti,pcm5122", },
{ .compatible = "ti,pcm5141", },
{ .compatible = "ti,pcm5142", },
+ { .compatible = "ti,tas5754", },
+ { .compatible = "ti,tas5756", },
{ }
};
MODULE_DEVICE_TABLE(of, pcm512x_of_match);
@@ -48,6 +48,7 @@ struct pcm512x_priv {
int mute;
struct mutex mutex;
unsigned int bclk_ratio;
+ int tas_device;
};
/*
@@ -927,6 +928,20 @@ static int pcm512x_set_dividers(struct snd_soc_dai *dai,
bclk_div = DIV_ROUND_CLOSEST(sck_rate, bclk_rate);
mck_rate = sck_rate;
+ if (pcm512x->tas_device) {
+ /* set necessary PLL coeffs for amp
+ * according to spec only 2x and 4x MCLKs
+ * possible
+ */
+ ret = regmap_write(pcm512x->regmap,
+ PCM512x_PLL_COEFF_0, 0x01);
+ if (mck_rate > 25000000UL)
+ ret = regmap_write(pcm512x->regmap,
+ PCM512x_PLL_COEFF_1, 0x02);
+ else
+ ret = regmap_write(pcm512x->regmap,
+ PCM512x_PLL_COEFF_1, 0x04);
+ }
} else {
ret = snd_soc_params_to_bclk(params);
if (ret < 0) {
@@ -1258,10 +1273,18 @@ static int pcm512x_hw_params(struct snd_pcm_substream *substream,
return ret;
}
- ret = regmap_update_bits(pcm512x->regmap, PCM512x_PLL_EN,
- PCM512x_PLLE, 0);
+ if (!pcm512x->tas_device) {
+ ret = regmap_update_bits(pcm512x->regmap,
+ PCM512x_PLL_EN, PCM512x_PLLE, 0);
+ } else {
+ /* leave PLL enabled for amp clocking */
+ ret = regmap_write(pcm512x->regmap,
+ PCM512x_PLL_EN, 0x01);
+ dev_dbg(component->dev, "Enabling PLL for TAS575x\n");
+ }
+
if (ret != 0) {
- dev_err(component->dev, "Failed to disable pll: %d\n", ret);
+ dev_err(component->dev, "Failed to set pll mode: %d\n", ret);
return ret;
}
}
@@ -1659,6 +1682,11 @@ int pcm512x_probe(struct device *dev, struct regmap *regmap)
ret = -EINVAL;
goto err_pm;
}
+
+ if (!strcmp(np->name, "tas5756") ||
+ !strcmp(np->name, "tas5754"))
+ pcm512x->tas_device = 1;
+ dev_dbg(dev, "Device ID: %s\n", np->name);
}
#endif
Enables the existing pcm512x driver to control the almost compatible TAS5754 and -76 amplifers. Both amplifiers support only an I2C interface and the internal PLL must be always on to provide necessary clocks to the amplifier section. Tested on TAS5756 with support from Andreas Arbesser-Krasser from Texas Instruments <a-krasser@ti.com> Signed-off-by: Joerg Schambacher <joerg.hifiberry@gmail.com> --- sound/soc/codecs/pcm512x-i2c.c | 4 ++++ sound/soc/codecs/pcm512x.c | 34 +++++++++++++++++++++++++++++++--- 2 files changed, 35 insertions(+), 3 deletions(-)