mbox series

[0/3] drm/msm/mdp5: Emit vsync signal often enough

Message ID 20210406214726.131534-1-marijn.suijten@somainline.org
Headers show
Series drm/msm/mdp5: Emit vsync signal often enough | expand

Message

Marijn Suijten April 6, 2021, 9:47 p.m. UTC 
This set of patches corrects and improves VSync-related register setup
on the MDP5 block.  Values written to the registers were way too high
leading to the MDSS block counting way too many ticks on the vclk before
emitting a vsync interrupt, resulting in significant update issues on
command- and video-mode panels.  With lower values - that match those of
downstream kernels - the panels on Sony devices (Xperia X, XA2 Ultra,
and more) update at an acceptable rate without "pp_done" timeouts.

The Driver-IC in these panels is also able to drive an interrupt line
and a future patchset will enable the use of this "disp-te" GPIO beyond
acquiring it in dsi_host.  This fixes panel framerate the correct way
(instead of running at half the desired framerate), but these patches
are still needed to aid development now and shorten lockup times when
the TE interrupt misbehaves by not arriving at all.

AngeloGioacchino Del Regno (1):
  drm/msm/mdp5: Disable pingpong autorefresh at tearcheck init

Marijn Suijten (2):
  drm/msm/mdp5: Configure PP_SYNC_HEIGHT to double the vtotal
  drm/msm/mdp5: Do not multiply vclk line count by 100

 drivers/gpu/drm/msm/disp/mdp5/mdp5_cmd_encoder.c | 11 ++++++-----
 1 file changed, 6 insertions(+), 5 deletions(-)