diff --git a/drivers/pci/controller/dwc/Kconfig b/drivers/pci/controller/dwc/Kconfig
index 5ac021dbd46a..591c4109ed62 100644
--- a/drivers/pci/controller/dwc/Kconfig
+++ b/drivers/pci/controller/dwc/Kconfig
@@ -268,6 +268,7 @@ config PCIE_DW_PLAT_EP
 config PCIE_QCOM
 	bool "Qualcomm PCIe controller (host mode)"
 	depends on OF && (ARCH_QCOM || COMPILE_TEST)
+	depends on QCOM_COMMAND_DB || QCOM_COMMAND_DB=n
 	depends on PCI_MSI
 	select PCIE_DW_HOST
 	select CRC8
diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 3d77269e70da..a9e24fcd1f66 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -30,13 +30,18 @@
 #include <linux/reset.h>
 #include <linux/slab.h>
 #include <linux/types.h>
+#include <soc/qcom/cmd-db.h>
 
 #include "../../pci.h"
 #include "pcie-designware.h"
 
+#include <dt-bindings/interconnect/qcom,icc.h>
+#include <dt-bindings/interconnect/qcom,rpm-icc.h>
+
 /* PARF registers */
 #define PARF_SYS_CTRL				0x00
 #define PARF_PM_CTRL				0x20
+#define PARF_PM_STTS				0x24
 #define PARF_PCS_DEEMPH				0x34
 #define PARF_PCS_SWING				0x38
 #define PARF_PHY_CTRL				0x40
@@ -80,7 +85,10 @@
 #define L1_CLK_RMV_DIS				BIT(1)
 
 /* PARF_PM_CTRL register fields */
-#define REQ_NOT_ENTR_L1				BIT(5)
+#define REQ_NOT_ENTR_L1				BIT(5) /* "Prevent L0->L1" */
+
+/* PARF_PM_STTS register fields */
+#define PM_ENTER_L23				BIT(5)
 
 /* PARF_PCS_DEEMPH register fields */
 #define PCS_DEEMPH_TX_DEEMPH_GEN1(x)		FIELD_PREP(GENMASK(21, 16), x)
@@ -122,6 +130,7 @@
 
 /* ELBI_SYS_CTRL register fields */
 #define ELBI_SYS_CTRL_LT_ENABLE			BIT(0)
+#define ELBI_SYS_CTRL_PME_TURNOFF_MSG		BIT(4)
 
 /* AXI_MSTR_RESP_COMP_CTRL0 register fields */
 #define CFG_REMOTE_RD_REQ_BRIDGE_SIZE_2K	0x4
@@ -244,6 +253,7 @@ struct qcom_pcie {
 	const struct qcom_pcie_cfg *cfg;
 	struct dentry *debugfs;
 	bool suspended;
+	bool soc_is_rpmh;
 };
 
 #define to_qcom_pcie(x)		dev_get_drvdata((x)->dev)
@@ -273,6 +283,24 @@ static int qcom_pcie_start_link(struct dw_pcie *pci)
 	return 0;
 }
 
+static int qcom_pcie_stop_link(struct dw_pcie *pci)
+{
+	struct qcom_pcie *pcie = to_qcom_pcie(pci);
+	u32 ret_l23, val;
+
+	writel(ELBI_SYS_CTRL_PME_TURNOFF_MSG, pcie->elbi + ELBI_SYS_CTRL);
+	readl(pcie->elbi + ELBI_SYS_CTRL);
+
+	ret_l23 = readl_poll_timeout(pcie->parf + PARF_PM_STTS, val,
+				     val & PM_ENTER_L23, 10000, 100000);
+	if (ret_l23) {
+		dev_err(pci->dev, "Failed to enter L2/L3\n");
+		return -ETIMEDOUT;
+	}
+
+	return 0;
+}
+
 static void qcom_pcie_clear_hpc(struct dw_pcie *pci)
 {
 	u16 offset = dw_pcie_find_capability(pci, PCI_CAP_ID_EXP);
@@ -991,9 +1019,19 @@ static void qcom_pcie_host_post_init_2_7_0(struct qcom_pcie *pcie)
 static void qcom_pcie_deinit_2_7_0(struct qcom_pcie *pcie)
 {
 	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
+	u32 val;
+
+	/* Disable PCIe clocks and resets */
+	val = readl(pcie->parf + PARF_PHY_CTRL);
+	val |= PHY_TEST_PWR_DOWN;
+	writel(val, pcie->parf + PARF_PHY_CTRL);
+	readl(pcie->parf + PARF_PHY_CTRL);
 
 	clk_bulk_disable_unprepare(res->num_clks, res->clks);
 
+	reset_control_assert(res->rst);
+	usleep_range(2000, 2500);
+
 	regulator_bulk_disable(ARRAY_SIZE(res->supplies), res->supplies);
 }
 
@@ -1553,6 +1591,9 @@ static int qcom_pcie_probe(struct platform_device *pdev)
 		goto err_phy_exit;
 	}
 
+	/* If the soc features RPMh, cmd_db must have been prepared by now */
+	pcie->soc_is_rpmh = !cmd_db_ready();
+
 	qcom_pcie_icc_update(pcie);
 
 	if (pcie->mhi)
@@ -1569,60 +1610,89 @@ static int qcom_pcie_probe(struct platform_device *pdev)
 	return ret;
 }
 
-static int qcom_pcie_suspend_noirq(struct device *dev)
+static int qcom_pcie_resume_noirq(struct device *dev)
 {
 	struct qcom_pcie *pcie = dev_get_drvdata(dev);
 	int ret;
 
 	/*
-	 * Set minimum bandwidth required to keep data path functional during
-	 * suspend.
+	 * Undo the tag change from qcom_pcie_suspend_noirq first in case
+	 * RPM(h) spontaneously decides to power collapse the platform based
+	 * on other inputs.
 	 */
-	ret = icc_set_bw(pcie->icc_mem, 0, kBps_to_icc(1));
+	icc_set_tag(pcie->icc_mem, pcie->soc_is_rpmh ? QCOM_ICC_TAG_ALWAYS : RPM_ALWAYS_TAG);
+	/* Flush the tag change */
+	ret = icc_set_bw(pcie->icc_mem, 0, pcie->last_bw);
 	if (ret) {
-		dev_err(dev, "Failed to set interconnect bandwidth: %d\n", ret);
+		dev_err(pcie->pci->dev, "failed to set interconnect bandwidth: %d\n", ret);
 		return ret;
 	}
 
-	pcie->last_bw = kBps_to_icc(1);
+	/* Only check this now to make sure the icc vote is in before going furhter. */
+	if (!pcie->suspended)
+		return 0;
 
-	/*
-	 * Turn OFF the resources only for controllers without active PCIe
-	 * devices. For controllers with active devices, the resources are kept
-	 * ON and the link is expected to be in L0/L1 (sub)states.
-	 *
-	 * Turning OFF the resources for controllers with active PCIe devices
-	 * will trigger access violation during the end of the suspend cycle,
-	 * as kernel tries to access the PCIe devices config space for masking
-	 * MSIs.
-	 *
-	 * Also, it is not desirable to put the link into L2/L3 state as that
-	 * implies VDD supply will be removed and the devices may go into
-	 * powerdown state. This will affect the lifetime of the storage devices
-	 * like NVMe.
-	 */
-	if (!dw_pcie_link_up(pcie->pci)) {
-		qcom_pcie_host_deinit(&pcie->pci->pp);
-		pcie->suspended = true;
-	}
+	ret = qcom_pcie_host_init(&pcie->pci->pp);
+	if (ret)
+		goto revert_icc_tag;
+
+	dw_pcie_setup_rc(&pcie->pci->pp);
+
+	ret = qcom_pcie_start_link(pcie->pci);
+	if (ret)
+		goto deinit_host;
+
+	/* Ignore the retval, the devices may come up later. */
+	dw_pcie_wait_for_link(pcie->pci);
+
+	qcom_pcie_icc_update(pcie);
+
+	pcie->suspended = false;
 
 	return 0;
+
+deinit_host:
+	qcom_pcie_host_deinit(&pcie->pci->pp);
+revert_icc_tag:
+	icc_set_tag(pcie->icc_mem, pcie->soc_is_rpmh ? QCOM_ICC_TAG_WAKE : RPM_ACTIVE_TAG);
+	/* Ignore the retval, failing here would be tragic anyway.. */
+	icc_set_bw(pcie->icc_mem, 0, pcie->last_bw);
+
+	return ret;
 }
 
-static int qcom_pcie_resume_noirq(struct device *dev)
+static int qcom_pcie_suspend_noirq(struct device *dev)
 {
 	struct qcom_pcie *pcie = dev_get_drvdata(dev);
 	int ret;
 
-	if (pcie->suspended) {
-		ret = qcom_pcie_host_init(&pcie->pci->pp);
+	if (pcie->suspended)
+		return 0;
+
+	if (dw_pcie_link_up(pcie->pci)) {
+		ret = qcom_pcie_stop_link(pcie->pci);
 		if (ret)
 			return ret;
+	}
 
-		pcie->suspended = false;
+	qcom_pcie_host_deinit(&pcie->pci->pp);
+
+	/*
+	 * The PCIe RC may be covertly accessed by the secure firmware on sleep exit.
+	 * Use the WAKE bucket to let RPMh pull the plug on PCIe in sleep,
+	 * but guarantee it comes back for resume.
+	 */
+	icc_set_tag(pcie->icc_mem, pcie->soc_is_rpmh ? QCOM_ICC_TAG_WAKE : RPM_ACTIVE_TAG);
+	/* Flush the tag change */
+	ret = icc_set_bw(pcie->icc_mem, 0, pcie->last_bw);
+	if (ret) {
+		dev_err(pcie->pci->dev, "failed to set interconnect bandwidth: %d\n", ret);
+
+		/* Revert everything and hope the next icc_set_bw goes through.. */
+		return qcom_pcie_resume_noirq(dev);
 	}
 
-	qcom_pcie_icc_update(pcie);
+	pcie->suspended = true;
 
 	return 0;
 }
