Toggle navigation
Patchwork
devicetree
Patches
Bundles
About this project
Login
Register
Mail settings
Show patches with
: Series =
ARM: at91: pm: add support for sama7g5
| 24 patches
Series
Submitter
State
any
Action Required
New
Under Review
Accepted
Rejected
RFC
Not Applicable
Changes Requested
Awaiting Upstream
Superseded
Deferred
Search
Archived
No
Yes
Both
Delegate
------
Nobody
andy.doan@linaro.org
andy.doan@linaro.org
Apply
Patch
Series
S/W/F
Date
Submitter
Delegate
State
[v3,24/24] ARM: at91: pm: add sama7g5 shdwc
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,23/24] ARM: at91: pm: add pm support for SAMA7G5
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,22/24] ARM: at91: sama7: introduce sama7 SoC family
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
New
[v3,21/24] ARM: at91: pm: add sama7g5's pmc
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,20/24] ARM: at91: pm: add backup mode support for SAMA7G5
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,19/24] ARM: at91: pm: save ddr phy calibration data to securam
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,18/24] ARM: at91: pm: add sama7g5 ddr phy controller
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,17/24] ARM: at91: pm: add sama7g5 ddr controller
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,16/24] dt-bindings: atmel-sysreg: add bindings for sama7g5
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,15/24] ARM: at91: pm: wait for ddr power mode off
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,14/24] ARM: at91: pm: add support for 2.5V LDO regulator control
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,13/24] ARM: at91: pm: add support for MCK1..4 save/restore for ulp modes
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,12/24] ARM: at91: pm: add self-refresh support for sama7g5
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,11/24] ARM: at91: ddr: add registers definitions for sama7g5's ddr
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,10/24] ARM: at91: sfrbu: add sfrbu registers definitions for sama7g5
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,09/24] ARM: at91: pm: add support for waiting MCK1..4
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,08/24] ARM: at91: pm: s/CONFIG_SOC_SAM9X60/CONFIG_HAVE_AT91_SAM9X60_PLL/g
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,07/24] ARM: at91: pm: avoid push and pop on stack while memory is in self-refersh
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,06/24] ARM: at91: pm: use r7 instead of tmp1
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,05/24] ARM: at91: pm: do not initialize pdev
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,04/24] ARM: at91: pm: check for different controllers in at91_pm_modes_init()
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,03/24] ARM: at91: pm: document at91_soc_pm structure
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,02/24] ARM: at91: pm: move the setup of soc_pm.bu->suspended
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted
[v3,01/24] ARM: at91: pm: move pm_bu to soc_pm data structure
ARM: at91: pm: add support for sama7g5
-
-
-
2021-04-15
Claudiu Beznea
Accepted