@@ -21,6 +21,10 @@ described in dsa/dsa.txt. If the QCA8K switch is connect to a SoC's external
mdio-bus each subnode describing a port needs to have a valid phandle
referencing the internal PHY it is connected to. This is because there's no
N:N mapping of port and PHY id.
+To declare the internal mdio-bus configuration, declare a mdio node in the
+switch node and declare the phandle for the port referencing the internal
+PHY is connected to. In this config a internal mdio-bus is registered and
+the mdio MASTER is used as communication.
Don't use mixed external and internal mdio-bus configurations, as this is
not supported by the hardware.
@@ -150,26 +154,61 @@ for the internal master mdio-bus configuration:
port@1 {
reg = <1>;
label = "lan1";
+ phy-mode = "internal";
+ phy-handle = <&phy_port1>;
};
port@2 {
reg = <2>;
label = "lan2";
+ phy-mode = "internal";
+ phy-handle = <&phy_port2>;
};
port@3 {
reg = <3>;
label = "lan3";
+ phy-mode = "internal";
+ phy-handle = <&phy_port3>;
};
port@4 {
reg = <4>;
label = "lan4";
+ phy-mode = "internal";
+ phy-handle = <&phy_port4>;
};
port@5 {
reg = <5>;
label = "wan";
+ phy-mode = "internal";
+ phy-handle = <&phy_port5>;
+ };
+ };
+
+ mdio {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ phy_port1: phy@0 {
+ reg = <0>;
+ };
+
+ phy_port2: phy@1 {
+ reg = <1>;
+ };
+
+ phy_port3: phy@2 {
+ reg = <2>;
+ };
+
+ phy_port4: phy@3 {
+ reg = <3>;
+ };
+
+ phy_port5: phy@4 {
+ reg = <4>;
};
};
};