@@ -2420,6 +2420,13 @@ spi3m1_cs1: spi3m1-cs1 {
};
tsadc {
+ /omit-if-no-ref/
+ tsadc_pin: tsadc-pin {
+ rockchip,pins =
+ /* tsadc_pin */
+ <0 RK_PA1 0 &pcfg_pull_none>;
+ };
+
/omit-if-no-ref/
tsadcm0_shut: tsadcm0-shut {
rockchip,pins =
@@ -50,6 +50,7 @@ cpu0: cpu@0 {
compatible = "arm,cortex-a55";
reg = <0x0 0x0>;
clocks = <&scmi_clk 0>;
+ #cooling-cells = <2>;
enable-method = "psci";
operating-points-v2 = <&cpu0_opp_table>;
};
@@ -58,6 +59,7 @@ cpu1: cpu@100 {
device_type = "cpu";
compatible = "arm,cortex-a55";
reg = <0x0 0x100>;
+ #cooling-cells = <2>;
enable-method = "psci";
operating-points-v2 = <&cpu0_opp_table>;
};
@@ -66,6 +68,7 @@ cpu2: cpu@200 {
device_type = "cpu";
compatible = "arm,cortex-a55";
reg = <0x0 0x200>;
+ #cooling-cells = <2>;
enable-method = "psci";
operating-points-v2 = <&cpu0_opp_table>;
};
@@ -74,6 +77,7 @@ cpu3: cpu@300 {
device_type = "cpu";
compatible = "arm,cortex-a55";
reg = <0x0 0x300>;
+ #cooling-cells = <2>;
enable-method = "psci";
operating-points-v2 = <&cpu0_opp_table>;
};
@@ -773,6 +777,72 @@ uart9: serial@fe6d0000 {
status = "disabled";
};
+ thermal_zones: thermal-zones {
+ cpu_thermal: cpu-thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <1000>;
+
+ thermal-sensors = <&tsadc 0>;
+
+ trips {
+ cpu_alert0: cpu_alert0 {
+ temperature = <70000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+ cpu_alert1: cpu_alert1 {
+ temperature = <75000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+ cpu_crit: cpu_crit {
+ temperature = <95000>;
+ hysteresis = <2000>;
+ type = "critical";
+ };
+ };
+
+ cooling-maps {
+ map0 {
+ trip = <&cpu_alert0>;
+ cooling-device =
+ <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+ <&cpu1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+ <&cpu2 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+ <&cpu3 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+ };
+ };
+ };
+
+ gpu_thermal: gpu-thermal {
+ polling-delay-passive = <20>; /* milliseconds */
+ polling-delay = <1000>; /* milliseconds */
+
+ thermal-sensors = <&tsadc 1>;
+ };
+ };
+
+ tsadc: tsadc@fe710000 {
+ compatible = "rockchip,rk3568-tsadc";
+ reg = <0x0 0xfe710000 0x0 0x100>;
+ interrupts = <GIC_SPI 115 IRQ_TYPE_LEVEL_HIGH>;
+ assigned-clocks = <&cru CLK_TSADC_TSEN>, <&cru CLK_TSADC>;
+ assigned-clock-rates = <17000000>, <700000>;
+ clocks = <&cru CLK_TSADC>, <&cru PCLK_TSADC>;
+ clock-names = "tsadc", "apb_pclk";
+ resets = <&cru SRST_TSADC>, <&cru SRST_P_TSADC>,
+ <&cru SRST_TSADCPHY>;
+ reset-names = "tsadc", "tsadc-apb", "tsadc-phy";
+ rockchip,grf = <&grf>;
+ rockchip,hw-tshut-temp = <95000>;
+ pinctrl-names = "init", "default", "sleep";
+ pinctrl-0 = <&tsadc_pin>;
+ pinctrl-1 = <&tsadc_shutorg>;
+ pinctrl-2 = <&tsadc_pin>;
+ #thermal-sensor-cells = <1>;
+ status = "disabled";
+ };
+
saradc: saradc@fe720000 {
compatible = "rockchip,rk3568-saradc", "rockchip,rk3399-saradc";
reg = <0x0 0xfe720000 0x0 0x100>;
Add the thermal and tsadc nodes to the rk3568 device tree. There are two sensors, one for the cpu, one for the gpu. Signed-off-by: Peter Geis <pgwipeout@gmail.com> --- .../boot/dts/rockchip/rk3568-pinctrl.dtsi | 7 ++ arch/arm64/boot/dts/rockchip/rk356x.dtsi | 70 +++++++++++++++++++ 2 files changed, 77 insertions(+)