diff --git a/MAINTAINERS b/MAINTAINERS
index 80f3544d07aa..b15bf6e2485c 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -534,6 +534,7 @@ S:	Maintained
 F:	Documentation/devicetree/bindings/*/adi,adp5585*.yaml
 F:	drivers/gpio/gpio-adp5585.c
 F:	drivers/mfd/adp5585.c
+F:	drivers/pwm/pwm-adp5585.c
 F:	include/linux/mfd/adp5585.h
 
 ADP5588 QWERTY KEYPAD AND IO EXPANDER DRIVER (ADP5588/ADP5587)
diff --git a/drivers/pwm/Kconfig b/drivers/pwm/Kconfig
index 1dd7921194f5..b778ecee3e9b 100644
--- a/drivers/pwm/Kconfig
+++ b/drivers/pwm/Kconfig
@@ -47,6 +47,13 @@ config PWM_AB8500
 	  To compile this driver as a module, choose M here: the module
 	  will be called pwm-ab8500.
 
+config PWM_ADP5585
+	tristate "ADP5585 PWM support"
+	depends on MFD_ADP5585
+	help
+	  This option enables support for the PWM function found in the Analog
+	  Devices ADP5585.
+
 config PWM_APPLE
 	tristate "Apple SoC PWM support"
 	depends on ARCH_APPLE || COMPILE_TEST
diff --git a/drivers/pwm/Makefile b/drivers/pwm/Makefile
index 90913519f11a..f24d518d20f2 100644
--- a/drivers/pwm/Makefile
+++ b/drivers/pwm/Makefile
@@ -1,6 +1,7 @@
 # SPDX-License-Identifier: GPL-2.0
 obj-$(CONFIG_PWM)		+= core.o
 obj-$(CONFIG_PWM_AB8500)	+= pwm-ab8500.o
+obj-$(CONFIG_PWM_ADP5585)	+= pwm-adp5585.o
 obj-$(CONFIG_PWM_APPLE)		+= pwm-apple.o
 obj-$(CONFIG_PWM_ATMEL)		+= pwm-atmel.o
 obj-$(CONFIG_PWM_ATMEL_HLCDC_PWM)	+= pwm-atmel-hlcdc.o
diff --git a/drivers/pwm/pwm-adp5585.c b/drivers/pwm/pwm-adp5585.c
new file mode 100644
index 000000000000..7f226c287efe
--- /dev/null
+++ b/drivers/pwm/pwm-adp5585.c
@@ -0,0 +1,189 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/*
+ * Analog Devices ADP5585 PWM driver
+ *
+ * Copyright 2022 NXP
+ * Copyright 2024 Ideas on Board Oy
+ *
+ * Limitations:
+ * - The .apply() operation executes atomically, but may not wait for the
+ *   period to complete (this is not documented and would need to be tested).
+ * - Disabling the PWM drives the output pin to a low level immediately.
+ * - The hardware can only generate normal polarity output.
+ */
+
+#include <linux/device.h>
+#include <linux/err.h>
+#include <linux/math64.h>
+#include <linux/mfd/adp5585.h>
+#include <linux/minmax.h>
+#include <linux/module.h>
+#include <linux/platform_device.h>
+#include <linux/pwm.h>
+#include <linux/regmap.h>
+#include <linux/time.h>
+#include <linux/types.h>
+
+#define ADP5585_PWM_CHAN_NUM		1
+
+#define ADP5585_PWM_OSC_FREQ_HZ		1000000U
+#define ADP5585_PWM_MIN_PERIOD_NS	(2ULL * NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ)
+#define ADP5585_PWM_MAX_PERIOD_NS	(2ULL * 0xffff * NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ)
+
+static int pwm_adp5585_request(struct pwm_chip *chip, struct pwm_device *pwm)
+{
+	struct regmap *regmap = pwmchip_get_drvdata(chip);
+	int ret;
+
+	ret = regmap_update_bits(regmap, ADP5585_PIN_CONFIG_C,
+				 ADP5585_R3_EXTEND_CFG_MASK,
+				 ADP5585_R3_EXTEND_CFG_PWM_OUT);
+	if (ret)
+		return ret;
+
+	return regmap_update_bits(regmap, ADP5585_GENERAL_CFG,
+				  ADP5585_OSC_EN, ADP5585_OSC_EN);
+}
+
+static void pwm_adp5585_free(struct pwm_chip *chip, struct pwm_device *pwm)
+{
+	struct regmap *regmap = pwmchip_get_drvdata(chip);
+
+	regmap_update_bits(regmap, ADP5585_PIN_CONFIG_C,
+			   ADP5585_R3_EXTEND_CFG_MASK,
+			   ADP5585_R3_EXTEND_CFG_GPIO4);
+	regmap_update_bits(regmap, ADP5585_GENERAL_CFG,
+			   ADP5585_OSC_EN, 0);
+}
+
+static int pwm_adp5585_apply(struct pwm_chip *chip,
+			     struct pwm_device *pwm,
+			     const struct pwm_state *state)
+{
+	struct regmap *regmap = pwmchip_get_drvdata(chip);
+	u64 period, duty_cycle;
+	u32 on, off;
+	int ret;
+
+	if (!state->enabled)
+		return regmap_update_bits(regmap, ADP5585_PWM_CFG,
+					  ADP5585_PWM_EN, 0);
+
+	if (state->polarity != PWM_POLARITY_NORMAL)
+		return -EINVAL;
+
+	if (state->period < ADP5585_PWM_MIN_PERIOD_NS)
+		return -EINVAL;
+
+	period = min(state->period, ADP5585_PWM_MAX_PERIOD_NS);
+	duty_cycle = min(state->duty_cycle, period);
+
+	/*
+	 * Compute the on and off time. As the internal oscillator frequency is
+	 * 1MHz, the calculation can be simplified without loss of precision.
+	 */
+	on = div_u64(duty_cycle, NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ);
+	off = div_u64(period, NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ) - on;
+
+	ret = regmap_write(regmap, ADP5585_PWM_OFFT_LOW,
+			   off & 0xff);
+	if (ret)
+		return ret;
+	ret = regmap_write(regmap, ADP5585_PWM_OFFT_HIGH,
+			   (off >> 8) & 0xff);
+	if (ret)
+		return ret;
+	ret = regmap_write(regmap, ADP5585_PWM_ONT_LOW,
+			   on & 0xff);
+	if (ret)
+		return ret;
+	ret = regmap_write(regmap, ADP5585_PWM_ONT_HIGH,
+			   (on >> 8) & 0xff);
+	if (ret)
+		return ret;
+
+	/* Enable PWM in continuous mode and no external AND'ing. */
+	ret = regmap_update_bits(regmap, ADP5585_PWM_CFG,
+				 ADP5585_PWM_IN_AND | ADP5585_PWM_MODE |
+				 ADP5585_PWM_EN, ADP5585_PWM_EN);
+	if (ret)
+		return ret;
+
+	return 0;
+}
+
+static int pwm_adp5585_get_state(struct pwm_chip *chip,
+				 struct pwm_device *pwm,
+				 struct pwm_state *state)
+{
+	struct regmap *regmap = pwmchip_get_drvdata(chip);
+	unsigned int on, off;
+	unsigned int val;
+
+	regmap_read(regmap, ADP5585_PWM_OFFT_LOW, &off);
+	regmap_read(regmap, ADP5585_PWM_OFFT_HIGH, &val);
+	off |= val << 8;
+
+	regmap_read(regmap, ADP5585_PWM_ONT_LOW, &on);
+	regmap_read(regmap, ADP5585_PWM_ONT_HIGH, &val);
+	on |= val << 8;
+
+	state->duty_cycle = on * (NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ);
+	state->period = (on + off) * (NSEC_PER_SEC / ADP5585_PWM_OSC_FREQ_HZ);
+
+	state->polarity = PWM_POLARITY_NORMAL;
+
+	regmap_read(regmap, ADP5585_PWM_CFG, &val);
+	state->enabled = !!(val & ADP5585_PWM_EN);
+
+	return 0;
+}
+
+static const struct pwm_ops adp5585_pwm_ops = {
+	.request = pwm_adp5585_request,
+	.free = pwm_adp5585_free,
+	.apply = pwm_adp5585_apply,
+	.get_state = pwm_adp5585_get_state,
+};
+
+static int adp5585_pwm_probe(struct platform_device *pdev)
+{
+	struct device *dev = &pdev->dev;
+	struct adp5585_dev *adp5585 = dev_get_drvdata(dev->parent);
+	struct pwm_chip *chip;
+	int ret;
+
+	chip = devm_pwmchip_alloc(dev, ADP5585_PWM_CHAN_NUM, 0);
+	if (IS_ERR(chip))
+		return PTR_ERR(chip);
+
+	device_set_of_node_from_dev(dev, dev->parent);
+
+	pwmchip_set_drvdata(chip, adp5585->regmap);
+	chip->ops = &adp5585_pwm_ops;
+
+	ret = devm_pwmchip_add(dev, chip);
+	if (ret)
+		return dev_err_probe(dev, ret, "failed to add PWM chip\n");
+
+	return 0;
+}
+
+static const struct platform_device_id adp5585_pwm_id_table[] = {
+	{ "adp5585-pwm" },
+	{ /* Sentinel */ },
+};
+MODULE_DEVICE_TABLE(platform, adp5585_pwm_id_table);
+
+static struct platform_driver adp5585_pwm_driver = {
+	.driver	= {
+		.name = "adp5585-pwm",
+	},
+	.probe = adp5585_pwm_probe,
+	.id_table = adp5585_pwm_id_table,
+};
+module_platform_driver(adp5585_pwm_driver);
+
+MODULE_AUTHOR("Xiaoning Wang <xiaoning.wang@nxp.com>");
+MODULE_DESCRIPTION("ADP5585 PWM Driver");
+MODULE_LICENSE("GPL");
