@@ -278,6 +278,37 @@ cmu_hsi0: clock-controller@10a00000 {
"dpgtc";
};
+ usbdrd: usb@10e00000 {
+ compatible = "samsung,exynos990-dwusb3",
+ "samsung,exynos850-dwusb3";
+ ranges = <0x0 0x10e00000 0x10000>;
+ clocks = <&cmu_hsi0 CLK_GOUT_HSI0_USB31DRD_BUS_CLK_EARLY>,
+ <&cmu_hsi0 CLK_GOUT_HSI0_USB31DRD_USB31DRD_REF_CLK_40>;
+ clock-names = "bus_early", "ref";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ status = "disabled";
+
+ usbdrd_dwc3: usb@0 {
+ compatible = "snps,dwc3";
+ reg = <0x0 0x10000>;
+ interrupts = <GIC_SPI 310 IRQ_TYPE_LEVEL_HIGH>;
+ phys = <&usbdrd_phy 0>;
+ phy-names = "usb2-phy";
+ };
+ };
+
+ usbdrd_phy: phy@10c00000 {
+ compatible = "samsung,exynos990-usbdrd-phy";
+ reg = <0x10c00000 0x100>;
+ clocks = <&cmu_hsi0 CLK_GOUT_HSI0_USB31DRD_ACLK_PHYCTRL>,
+ <&oscclk>;
+ clock-names = "phy", "ref";
+ samsung,pmu-syscon = <&pmu_system_controller>;
+ #phy-cells = <1>;
+ status = "disabled";
+ };
+
pinctrl_hsi1: pinctrl@13040000 {
compatible = "samsung,exynos990-pinctrl";
reg = <0x13040000 0x1000>;
Add USB controller and USB PHY controller nodes for use in the Exynos990 SoC. This SoC supports USB full-speed, high-speed and super-speed modes. Due to the inability to test PIPE3, USB super-speed is not enabled, and the USB PHY is only configured for UTMI+ operation for now. Signed-off-by: Igor Belwon <igor.belwon@mentallysanemainliners.org> --- arch/arm64/boot/dts/exynos/exynos990.dtsi | 31 +++++++++++++++++++++++++++++++ 1 file changed, 31 insertions(+)