| Message ID | 20181210173550.29643-1-manivannan.sadhasivam@linaro.org |
|---|---|
| Headers | show |
| Series | Add initial RDA8810PL SoC and Orange Pi boards support | expand |
Hi Daniel, On Wed, Dec 12, 2018 at 04:07:53PM +0100, Daniel Lezcano wrote: > On 10/12/2018 18:35, Manivannan Sadhasivam wrote: > > Add clock driver for RDA Micro RDA8810PL SoC supporting OSTIMER > > and HWTIMER. > > > > RDA8810PL has two independent timers: OSTIMER (56 bit) and HWTIMER > > (64 bit). Each timer provides optional interrupt support. In this > > driver, OSTIMER is used for clockevents and HWTIMER is used for > > clocksource. > > > > Signed-off-by: Andreas Färber <afaerber@suse.de> > > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org> > > The driver looks good to me. Do you want me to pick it up via my tree? > Yes, please do. Marc is going to pick up the irqchip driver but I'm not sure about the serial driver. The rest of the patches can be picked up by the ARM maintainers (I need to send another version for dropping Andreas from MAINTAINERS). Thanks, Mani > > --- > > drivers/clocksource/Kconfig | 8 ++ > > drivers/clocksource/Makefile | 1 + > > drivers/clocksource/timer-rda.c | 195 ++++++++++++++++++++++++++++++++ > > 3 files changed, 204 insertions(+) > > create mode 100644 drivers/clocksource/timer-rda.c > > > > diff --git a/drivers/clocksource/Kconfig b/drivers/clocksource/Kconfig > > index 55c77e44bb2d..598b592e03d7 100644 > > --- a/drivers/clocksource/Kconfig > > +++ b/drivers/clocksource/Kconfig > > @@ -105,6 +105,14 @@ config OWL_TIMER > > help > > Enables the support for the Actions Semi Owl timer driver. > > > > +config RDA_TIMER > > + bool "RDA timer driver" if COMPILE_TEST > > + depends on GENERIC_CLOCKEVENTS > > + select CLKSRC_MMIO > > + select TIMER_OF > > + help > > + Enables the support for the RDA Micro timer driver. > > + > > config SUN4I_TIMER > > bool "Sun4i timer driver" if COMPILE_TEST > > depends on HAS_IOMEM > > diff --git a/drivers/clocksource/Makefile b/drivers/clocksource/Makefile > > index dd9138104568..150020a90707 100644 > > --- a/drivers/clocksource/Makefile > > +++ b/drivers/clocksource/Makefile > > @@ -57,6 +57,7 @@ obj-$(CONFIG_OXNAS_RPS_TIMER) += timer-oxnas-rps.o > > obj-$(CONFIG_OWL_TIMER) += timer-owl.o > > obj-$(CONFIG_SPRD_TIMER) += timer-sprd.o > > obj-$(CONFIG_NPCM7XX_TIMER) += timer-npcm7xx.o > > +obj-$(CONFIG_RDA_TIMER) += timer-rda.o > > > > obj-$(CONFIG_ARC_TIMERS) += arc_timer.o > > obj-$(CONFIG_ARM_ARCH_TIMER) += arm_arch_timer.o > > diff --git a/drivers/clocksource/timer-rda.c b/drivers/clocksource/timer-rda.c > > new file mode 100644 > > index 000000000000..fd1199c189bf > > --- /dev/null > > +++ b/drivers/clocksource/timer-rda.c > > @@ -0,0 +1,195 @@ > > +// SPDX-License-Identifier: GPL-2.0+ > > +/* > > + * RDA8810PL SoC timer driver > > + * > > + * Copyright RDA Microelectronics Company Limited > > + * Copyright (c) 2017 Andreas Färber > > + * Copyright (c) 2018 Manivannan Sadhasivam > > + * > > + * RDA8810PL has two independent timers: OSTIMER (56 bit) and HWTIMER (64 bit). > > + * Each timer provides optional interrupt support. In this driver, OSTIMER is > > + * used for clockevents and HWTIMER is used for clocksource. > > + */ > > + > > +#include <linux/init.h> > > +#include <linux/interrupt.h> > > + > > +#include "timer-of.h" > > + > > +#define RDA_OSTIMER_LOADVAL_L 0x000 > > +#define RDA_OSTIMER_CTRL 0x004 > > +#define RDA_HWTIMER_LOCKVAL_L 0x024 > > +#define RDA_HWTIMER_LOCKVAL_H 0x028 > > +#define RDA_TIMER_IRQ_MASK_SET 0x02c > > +#define RDA_TIMER_IRQ_MASK_CLR 0x030 > > +#define RDA_TIMER_IRQ_CLR 0x034 > > + > > +#define RDA_OSTIMER_CTRL_ENABLE BIT(24) > > +#define RDA_OSTIMER_CTRL_REPEAT BIT(28) > > +#define RDA_OSTIMER_CTRL_LOAD BIT(30) > > + > > +#define RDA_TIMER_IRQ_MASK_OSTIMER BIT(0) > > + > > +#define RDA_TIMER_IRQ_CLR_OSTIMER BIT(0) > > + > > +static int rda_ostimer_start(void __iomem *base, bool periodic, u64 cycles) > > +{ > > + u32 ctrl, load_l; > > + > > + load_l = (u32)cycles; > > + ctrl = ((cycles >> 32) & 0xffffff); > > + ctrl |= RDA_OSTIMER_CTRL_LOAD | RDA_OSTIMER_CTRL_ENABLE; > > + if (periodic) > > + ctrl |= RDA_OSTIMER_CTRL_REPEAT; > > + /* Enable ostimer interrupt first */ > > + writel_relaxed(RDA_TIMER_IRQ_MASK_OSTIMER, > > + base + RDA_TIMER_IRQ_MASK_SET); > > + > > + /* Write low 32 bits first, high 24 bits are with ctrl */ > > + writel_relaxed(load_l, base + RDA_OSTIMER_LOADVAL_L); > > + writel_relaxed(ctrl, base + RDA_OSTIMER_CTRL); > > + > > + return 0; > > +} > > + > > +static int rda_ostimer_stop(void __iomem *base) > > +{ > > + /* Disable ostimer interrupt first */ > > + writel_relaxed(RDA_TIMER_IRQ_MASK_OSTIMER, > > + base + RDA_TIMER_IRQ_MASK_CLR); > > + > > + writel_relaxed(0, base + RDA_OSTIMER_CTRL); > > + > > + return 0; > > +} > > + > > +static int rda_ostimer_set_state_shutdown(struct clock_event_device *evt) > > +{ > > + struct timer_of *to = to_timer_of(evt); > > + > > + rda_ostimer_stop(timer_of_base(to)); > > + > > + return 0; > > +} > > + > > +static int rda_ostimer_set_state_oneshot(struct clock_event_device *evt) > > +{ > > + struct timer_of *to = to_timer_of(evt); > > + > > + rda_ostimer_stop(timer_of_base(to)); > > + > > + return 0; > > +} > > + > > +static int rda_ostimer_set_state_periodic(struct clock_event_device *evt) > > +{ > > + struct timer_of *to = to_timer_of(evt); > > + unsigned long cycles_per_jiffy; > > + > > + rda_ostimer_stop(timer_of_base(to)); > > + > > + cycles_per_jiffy = ((unsigned long long)NSEC_PER_SEC / HZ * > > + evt->mult) >> evt->shift; > > + rda_ostimer_start(timer_of_base(to), true, cycles_per_jiffy); > > + > > + return 0; > > +} > > + > > +static int rda_ostimer_tick_resume(struct clock_event_device *evt) > > +{ > > + return 0; > > +} > > + > > +static int rda_ostimer_set_next_event(unsigned long evt, > > + struct clock_event_device *ev) > > +{ > > + struct timer_of *to = to_timer_of(ev); > > + > > + rda_ostimer_start(timer_of_base(to), false, evt); > > + > > + return 0; > > +} > > + > > +static irqreturn_t rda_ostimer_interrupt(int irq, void *dev_id) > > +{ > > + struct clock_event_device *evt = dev_id; > > + struct timer_of *to = to_timer_of(evt); > > + > > + /* clear timer int */ > > + writel_relaxed(RDA_TIMER_IRQ_CLR_OSTIMER, > > + timer_of_base(to) + RDA_TIMER_IRQ_CLR); > > + > > + if (evt->event_handler) > > + evt->event_handler(evt); > > + > > + return IRQ_HANDLED; > > +} > > + > > +static struct timer_of rda_ostimer_of = { > > + .flags = TIMER_OF_IRQ | TIMER_OF_BASE, > > + > > + .clkevt = { > > + .name = "rda-ostimer", > > + .rating = 250, > > + .features = CLOCK_EVT_FEAT_PERIODIC | CLOCK_EVT_FEAT_ONESHOT | > > + CLOCK_EVT_FEAT_DYNIRQ, > > + .set_state_shutdown = rda_ostimer_set_state_shutdown, > > + .set_state_oneshot = rda_ostimer_set_state_oneshot, > > + .set_state_periodic = rda_ostimer_set_state_periodic, > > + .tick_resume = rda_ostimer_tick_resume, > > + .set_next_event = rda_ostimer_set_next_event, > > + }, > > + > > + .of_base = { > > + .name = "rda-timer", > > + .index = 0, > > + }, > > + > > + .of_irq = { > > + .name = "ostimer", > > + .handler = rda_ostimer_interrupt, > > + .flags = IRQF_TIMER, > > + }, > > +}; > > + > > +static u64 rda_hwtimer_read(struct clocksource *cs) > > +{ > > + void __iomem *base = timer_of_base(&rda_ostimer_of); > > + u32 lo, hi; > > + > > + /* Always read low 32 bits first */ > > + do { > > + lo = readl_relaxed(base + RDA_HWTIMER_LOCKVAL_L); > > + hi = readl_relaxed(base + RDA_HWTIMER_LOCKVAL_H); > > + } while (hi != readl_relaxed(base + RDA_HWTIMER_LOCKVAL_H)); > > + > > + return ((u64)hi << 32) | lo; > > +} > > + > > +static struct clocksource rda_hwtimer_clocksource = { > > + .name = "rda-timer", > > + .rating = 400, > > + .read = rda_hwtimer_read, > > + .mask = CLOCKSOURCE_MASK(64), > > + .flags = CLOCK_SOURCE_IS_CONTINUOUS, > > +}; > > + > > +static int __init rda_timer_init(struct device_node *np) > > +{ > > + unsigned long rate = 2000000; > > + int ret; > > + > > + ret = timer_of_init(np, &rda_ostimer_of); > > + if (ret) > > + return ret; > > + > > + clocksource_register_hz(&rda_hwtimer_clocksource, rate); > > + > > + clockevents_config_and_register(&rda_ostimer_of.clkevt, rate, > > + 0x2, UINT_MAX); > > + > > + return 0; > > +} > > + > > +TIMER_OF_DECLARE(rda8810pl, "rda,8810pl-timer", rda_timer_init); > > > > > -- > <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs > > Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | > <http://twitter.com/#!/linaroorg> Twitter | > <http://www.linaro.org/linaro-blog/> Blog >