@@ -110,6 +110,10 @@
#define PLL_IDLE_TIME 100 /* in milliseconds */
#define PLL_LOCK_TIME 100 /* in milliseconds */
+enum pipe3_mode { PIPE3_MODE_PCIE = 1,
+ PIPE3_MODE_SATA,
+ PIPE3_MODE_USBSS };
+
struct pipe3_dpll_params {
u16 m;
u8 n;
@@ -141,6 +145,7 @@ struct ti_pipe3 {
unsigned int power_reg; /* power reg. index within syscon */
unsigned int pcie_pcs_reg; /* pcs reg. index in syscon */
bool sata_refclk_enabled;
+ enum pipe3_mode mode;
};
static struct pipe3_dpll_map dpll_map_usb[] = {
@@ -163,6 +168,25 @@ static struct pipe3_dpll_map dpll_map_sata[] = {
{ }, /* Terminator */
};
+struct pipe3_data {
+ enum pipe3_mode mode;
+ struct pipe3_dpll_map *dpll_map;
+};
+
+static struct pipe3_data data_usb = {
+ .mode = PIPE3_MODE_USBSS,
+ .dpll_map = dpll_map_usb,
+};
+
+static struct pipe3_data data_sata = {
+ .mode = PIPE3_MODE_SATA,
+ .dpll_map = dpll_map_sata,
+};
+
+static struct pipe3_data data_pcie = {
+ .mode = PIPE3_MODE_PCIE,
+};
+
static inline u32 ti_pipe3_readl(void __iomem *addr, unsigned offset)
{
return __raw_readl(addr + offset);
@@ -340,7 +364,7 @@ static int ti_pipe3_init(struct phy *x)
* as recommended in AM572x TRM SPRUHZ6, section 18.5.2.2, table
* 18-1804.
*/
- if (of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-pcie")) {
+ if (phy->mode == PIPE3_MODE_PCIE) {
if (!phy->pcs_syscon) {
omap_control_pcie_pcs(phy->control_dev, 0x96);
return 0;
@@ -367,8 +391,7 @@ static int ti_pipe3_init(struct phy *x)
/* SATA has issues if re-programmed when locked */
val = ti_pipe3_readl(phy->pll_ctrl_base, PLL_STATUS);
- if ((val & PLL_LOCK) && of_device_is_compatible(phy->dev->of_node,
- "ti,phy-pipe3-sata"))
+ if ((val & PLL_LOCK) && phy->mode == PIPE3_MODE_SATA)
return ret;
/* Program the DPLL */
@@ -390,12 +413,11 @@ static int ti_pipe3_exit(struct phy *x)
/* If dpll_reset_syscon is not present we wont power down SATA DPLL
* due to Errata i783
*/
- if (of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-sata") &&
- !phy->dpll_reset_syscon)
+ if (phy->mode == PIPE3_MODE_SATA && !phy->dpll_reset_syscon)
return 0;
/* PCIe doesn't have internal DPLL */
- if (!of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-pcie")) {
+ if (phy->mode != PIPE3_MODE_PCIE) {
/* Put DPLL in IDLE mode */
val = ti_pipe3_readl(phy->pll_ctrl_base, PLL_CONFIGURATION2);
val |= PLL_IDLE;
@@ -418,7 +440,7 @@ static int ti_pipe3_exit(struct phy *x)
}
/* i783: SATA needs control bit toggle after PLL unlock */
- if (of_device_is_compatible(phy->dev->of_node, "ti,phy-pipe3-sata")) {
+ if (phy->mode == PIPE3_MODE_SATA) {
regmap_update_bits(phy->dpll_reset_syscon, phy->dpll_reset_reg,
SATA_PLL_SOFT_RESET, SATA_PLL_SOFT_RESET);
regmap_update_bits(phy->dpll_reset_syscon, phy->dpll_reset_reg,
@@ -443,7 +465,6 @@ static int ti_pipe3_get_clk(struct ti_pipe3 *phy)
{
struct clk *clk;
struct device *dev = phy->dev;
- struct device_node *node = dev->of_node;
phy->refclk = devm_clk_get(dev, "refclk");
if (IS_ERR(phy->refclk)) {
@@ -451,11 +472,11 @@ static int ti_pipe3_get_clk(struct ti_pipe3 *phy)
/* older DTBs have missing refclk in SATA PHY
* so don't bail out in case of SATA PHY.
*/
- if (!of_device_is_compatible(node, "ti,phy-pipe3-sata"))
+ if (phy->mode != PIPE3_MODE_SATA)
return PTR_ERR(phy->refclk);
}
- if (!of_device_is_compatible(node, "ti,phy-pipe3-sata")) {
+ if (phy->mode != PIPE3_MODE_SATA) {
phy->wkupclk = devm_clk_get(dev, "wkupclk");
if (IS_ERR(phy->wkupclk)) {
dev_err(dev, "unable to get wkupclk\n");
@@ -465,8 +486,7 @@ static int ti_pipe3_get_clk(struct ti_pipe3 *phy)
phy->wkupclk = ERR_PTR(-ENODEV);
}
- if (!of_device_is_compatible(node, "ti,phy-pipe3-pcie") ||
- phy->phy_power_syscon) {
+ if (phy->mode != PIPE3_MODE_PCIE || phy->phy_power_syscon) {
phy->sys_clk = devm_clk_get(dev, "sysclk");
if (IS_ERR(phy->sys_clk)) {
dev_err(dev, "unable to get sysclk\n");
@@ -474,7 +494,7 @@ static int ti_pipe3_get_clk(struct ti_pipe3 *phy)
}
}
- if (of_device_is_compatible(node, "ti,phy-pipe3-pcie")) {
+ if (phy->mode == PIPE3_MODE_PCIE) {
clk = devm_clk_get(dev, "dpll_ref");
if (IS_ERR(clk)) {
dev_err(dev, "unable to get dpll ref clk\n");
@@ -546,7 +566,7 @@ static int ti_pipe3_get_sysctrl(struct ti_pipe3 *phy)
phy->control_dev = &control_pdev->dev;
}
- if (of_device_is_compatible(node, "ti,phy-pipe3-pcie")) {
+ if (phy->mode == PIPE3_MODE_PCIE) {
phy->pcs_syscon = syscon_regmap_lookup_by_phandle(node,
"syscon-pcs");
if (IS_ERR(phy->pcs_syscon)) {
@@ -564,7 +584,7 @@ static int ti_pipe3_get_sysctrl(struct ti_pipe3 *phy)
}
}
- if (of_device_is_compatible(node, "ti,phy-pipe3-sata")) {
+ if (phy->mode == PIPE3_MODE_SATA) {
phy->dpll_reset_syscon = syscon_regmap_lookup_by_phandle(node,
"syscon-pllreset");
if (IS_ERR(phy->dpll_reset_syscon)) {
@@ -589,10 +609,9 @@ static int ti_pipe3_get_tx_rx_base(struct ti_pipe3 *phy)
{
struct resource *res;
struct device *dev = phy->dev;
- struct device_node *node = dev->of_node;
struct platform_device *pdev = to_platform_device(dev);
- if (!of_device_is_compatible(node, "ti,phy-pipe3-pcie"))
+ if (phy->mode != PIPE3_MODE_PCIE)
return 0;
res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
@@ -611,24 +630,12 @@ static int ti_pipe3_get_tx_rx_base(struct ti_pipe3 *phy)
static int ti_pipe3_get_pll_base(struct ti_pipe3 *phy)
{
struct resource *res;
- const struct of_device_id *match;
struct device *dev = phy->dev;
- struct device_node *node = dev->of_node;
struct platform_device *pdev = to_platform_device(dev);
- if (of_device_is_compatible(node, "ti,phy-pipe3-pcie"))
+ if (phy->mode == PIPE3_MODE_PCIE)
return 0;
- match = of_match_device(ti_pipe3_id_table, dev);
- if (!match)
- return -EINVAL;
-
- phy->dpll_map = (struct pipe3_dpll_map *)match->data;
- if (!phy->dpll_map) {
- dev_err(dev, "no DPLL data\n");
- return -EINVAL;
- }
-
res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
"pll_ctrl");
phy->pll_ctrl_base = devm_ioremap_resource(dev, res);
@@ -640,15 +647,28 @@ static int ti_pipe3_probe(struct platform_device *pdev)
struct ti_pipe3 *phy;
struct phy *generic_phy;
struct phy_provider *phy_provider;
- struct device_node *node = pdev->dev.of_node;
struct device *dev = &pdev->dev;
int ret;
+ const struct of_device_id *match;
+ struct pipe3_data *data;
phy = devm_kzalloc(dev, sizeof(*phy), GFP_KERNEL);
if (!phy)
return -ENOMEM;
- phy->dev = dev;
+ match = of_match_device(ti_pipe3_id_table, dev);
+ if (!match)
+ return -EINVAL;
+
+ data = (struct pipe3_data *)match->data;
+ if (!data) {
+ dev_err(dev, "no driver data\n");
+ return -EINVAL;
+ }
+
+ phy->dev = dev;
+ phy->mode = data->mode;
+ phy->dpll_map = data->dpll_map;
ret = ti_pipe3_get_pll_base(phy);
if (ret)
@@ -672,7 +692,7 @@ static int ti_pipe3_probe(struct platform_device *pdev)
/*
* Prevent auto-disable of refclk for SATA PHY due to Errata i783
*/
- if (of_device_is_compatible(node, "ti,phy-pipe3-sata")) {
+ if (phy->mode == PIPE3_MODE_SATA) {
if (!IS_ERR(phy->refclk)) {
clk_prepare_enable(phy->refclk);
phy->sata_refclk_enabled = true;
@@ -762,18 +782,19 @@ static void ti_pipe3_disable_clocks(struct ti_pipe3 *phy)
static const struct of_device_id ti_pipe3_id_table[] = {
{
.compatible = "ti,phy-usb3",
- .data = dpll_map_usb,
+ .data = &data_usb,
},
{
.compatible = "ti,omap-usb3",
- .data = dpll_map_usb,
+ .data = &data_usb,
},
{
.compatible = "ti,phy-pipe3-sata",
- .data = dpll_map_sata,
+ .data = &data_sata,
},
{
.compatible = "ti,phy-pipe3-pcie",
+ .data = &data_pcie,
},
{}
};
Introduce a mode property in the driver data so that we don't have to keep using "of_device_is_compatible()" throughtout the driver. No functional change. Signed-off-by: Roger Quadros <rogerq@ti.com> --- drivers/phy/ti/phy-ti-pipe3.c | 93 +++++++++++++++++++++-------------- 1 file changed, 57 insertions(+), 36 deletions(-) -- Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki