@@ -1387,7 +1387,6 @@ static int ixp4xx_eth_probe(struct platform_device *pdev)
SET_NETDEV_DEV(ndev, dev);
port = netdev_priv(ndev);
port->netdev = ndev;
- port->id = pdev->id;
/* Get the port resource and remap */
res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
@@ -1396,13 +1395,15 @@ static int ixp4xx_eth_probe(struct platform_device *pdev)
regs_phys = res->start;
port->regs = devm_ioremap_resource(dev, res);
- switch (port->id) {
- case IXP4XX_ETH_NPEA:
+ switch (res->start) {
+ case 0xc800c000:
+ port->id = IXP4XX_ETH_NPEA;
/* If the MDIO bus is not up yet, defer probe */
if (!mdio_bus)
return -EPROBE_DEFER;
break;
- case IXP4XX_ETH_NPEB:
+ case 0xc8009000:
+ port->id = IXP4XX_ETH_NPEB;
/*
* On all except IXP43x, NPE-B is used for the MDIO bus.
* If there is no NPE-B in the feature set, bail out, else
@@ -1419,7 +1420,8 @@ static int ixp4xx_eth_probe(struct platform_device *pdev)
if (!mdio_bus)
return -EPROBE_DEFER;
break;
- case IXP4XX_ETH_NPEC:
+ case 0xc800a000:
+ port->id = IXP4XX_ETH_NPEC;
/*
* IXP43x lacks NPE-B and uses NPE-C for the MDIO bus access,
* of there is no NPE-C, no bus, nothing works, so bail out.
The port->id was picked from the platform device .id field, but this is not supposed to be used for passing around random numbers in hardware. Identify the port ID number from the base address instead. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- drivers/net/ethernet/xscale/ixp4xx_eth.c | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) -- 2.20.1