@@ -64,6 +64,18 @@ Optional properties:
AVB_LINK signal.
- renesas,ether-link-active-low: boolean, specify when the AVB_LINK signal is
active-low instead of normal active-high.
+- renesas,rxc-delay-ps: Internal RX clock delay.
+ This property is mandatory and valid only on R-Car Gen3
+ and RZ/G2 SoCs.
+ Valid values are 0 and 1800.
+ A non-zero value is allowed only if phy-mode = "rgmii".
+ Zero is not supported on R-Car D3.
+- renesas,txc-delay-ps: Internal TX clock delay.
+ This property is mandatory and valid only on R-Car H3,
+ M3-W, M3-W+, M3-N, V3M, and V3H, and RZ/G2M and RZ/G2N.
+ Valid values are 0 and 2000.
+ A non-zero value is allowed only if phy-mode = "rgmii".
+ Zero is not supported on R-Car V3H.
Example:
@@ -105,8 +117,10 @@ Example:
"ch24";
clocks = <&cpg CPG_MOD 812>;
power-domains = <&cpg>;
- phy-mode = "rgmii-id";
+ phy-mode = "rgmii";
phy-handle = <&phy0>;
+ renesas,rxc-delay-ps = <0>;
+ renesas,txc-delay-ps = <2000>;
pinctrl-0 = <ðer_pins>;
pinctrl-names = "default";
@@ -115,18 +129,7 @@ Example:
#size-cells = <0>;
phy0: ethernet-phy@0 {
- rxc-skew-ps = <900>;
- rxdv-skew-ps = <0>;
- rxd0-skew-ps = <0>;
- rxd1-skew-ps = <0>;
- rxd2-skew-ps = <0>;
- rxd3-skew-ps = <0>;
- txc-skew-ps = <900>;
- txen-skew-ps = <0>;
- txd0-skew-ps = <0>;
- txd1-skew-ps = <0>;
- txd2-skew-ps = <0>;
- txd3-skew-ps = <0>;
+ rxc-skew-ps = <1500>;
reg = <0>;
interrupt-parent = <&gpio2>;
interrupts = <11 IRQ_TYPE_LEVEL_LOW>;
Some EtherAVB variants support internal clock delay configuration, which can add larger delays than the delays that are typically supported by the PHY (using an "rgmii-*id" PHY mode, and/or "[rt]xc-skew-ps" properties). Add properties for configuring the internal MAC delays. These properties are mandatory, even when specified as zero, to distinguish between old and new DTBs. Update the example accordingly. Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> --- .../devicetree/bindings/net/renesas,ravb.txt | 29 ++++++++++--------- 1 file changed, 16 insertions(+), 13 deletions(-)