From patchwork Fri Jul 10 09:23:18 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Rayagonda Kokatanur X-Patchwork-Id: 241267 List-Id: U-Boot discussion From: rayagonda.kokatanur at broadcom.com (Rayagonda Kokatanur) Date: Fri, 10 Jul 2020 14:53:18 +0530 Subject: [PATCH v4 0/7] add basic driver support for broadcom NS3 soc Message-ID: <20200710092325.5524-1-rayagonda.kokatanur@broadcom.com> This is the second patch set series prepared on top of the first patch set ("add initial support for broadcom NS3 soc"). This patch set will add following, -defconfig options for basic device like pinctrl, gpio, mmc, qspi, wdt, i2c and pcie. -start wdt service -Enable GPT commands -Enable EXT4 and FAT fs support Changes from v3: -Rebase on top of first patch set. Changes from v2: -Address review comments from Stefan Rose, Remove patch to stop and start wdt service from board files. Instead define CONFIG_WATCHDOG defconfig which takes care of wdt reset for every 1s. Changes from v1: -Address review comments from Simon, -include instead of and -remove include as its not required -Use if() instead of #if def -rearrange code in start_wdt() -remove #else part of #ifdef CONFIG_DT -Address review comments from Tom and Simon, Remove all dt patches as uboot should use the same dt file from Linux. Rayagonda Kokatanur (7): configs: ns3: enable pinctrl driver dt-bindings: pinctrl: add ns3 pads definition configs: ns3: enable BCM IPROC mmc driver configs: ns3: enable mmc commands configs: ns3: enable gpt commands configs: ns3: enable EXT4 and FAT fs support configs: ns3: enable sp805 watchdog driver configs/bcm_ns3_defconfig | 18 ++++++++ .../dt-bindings/pinctrl/brcm,pinctrl-ns3.h | 41 +++++++++++++++++++ 2 files changed, 59 insertions(+) create mode 100644 include/dt-bindings/pinctrl/brcm,pinctrl-ns3.h