From patchwork Wed Apr 29 02:35:11 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Peng Fan X-Patchwork-Id: 238787 List-Id: U-Boot discussion From: peng.fan at nxp.com (Peng Fan) Date: Wed, 29 Apr 2020 10:35:11 +0800 Subject: [PATCH 2/5] usb: gadget: sdp: use CONFIG_SDP_LOADADDR as default load address In-Reply-To: <20200429023514.9008-1-peng.fan@nxp.com> References: <20200429023514.9008-1-peng.fan@nxp.com> Message-ID: <20200429023514.9008-2-peng.fan@nxp.com> From: Frank Li If SDP_WRITE and SDP_JUMP addr is zero, use CONFIG_SDP_LOADADDR as default address Signed-off-by: Frank Li Signed-off-by: Peng Fan --- drivers/usb/gadget/Kconfig | 4 ++++ drivers/usb/gadget/f_sdp.c | 4 ++-- 2 files changed, 6 insertions(+), 2 deletions(-) diff --git a/drivers/usb/gadget/Kconfig b/drivers/usb/gadget/Kconfig index 58ca82d4de..46aa3fe954 100644 --- a/drivers/usb/gadget/Kconfig +++ b/drivers/usb/gadget/Kconfig @@ -122,6 +122,10 @@ config USB_GADGET_VBUS_DRAW This value will be used except for system-specific gadget drivers that have more specific information. +config SDP_LOADADDR + hex "Default load address at SDP_WRITE and SDP_JUMP" + default 0 + # Selected by UDC drivers that support high-speed operation. config USB_GADGET_DUALSPEED bool diff --git a/drivers/usb/gadget/f_sdp.c b/drivers/usb/gadget/f_sdp.c index 50836db4a0..1732a3acf1 100644 --- a/drivers/usb/gadget/f_sdp.c +++ b/drivers/usb/gadget/f_sdp.c @@ -276,7 +276,7 @@ static void sdp_rx_command_complete(struct usb_ep *ep, struct usb_request *req) sdp->error_status = SDP_WRITE_FILE_COMPLETE; sdp->state = SDP_STATE_RX_FILE_DATA; - sdp->dnl_address = be32_to_cpu(cmd->addr); + sdp->dnl_address = cmd->addr ? be32_to_cpu(cmd->addr) : CONFIG_SDP_LOADADDR; sdp->dnl_bytes_remaining = be32_to_cpu(cmd->cnt); sdp->dnl_bytes = sdp->dnl_bytes_remaining; sdp->next_state = SDP_STATE_IDLE; @@ -304,7 +304,7 @@ static void sdp_rx_command_complete(struct usb_ep *ep, struct usb_request *req) sdp->always_send_status = false; sdp->error_status = 0; - sdp->jmp_address = be32_to_cpu(cmd->addr); + sdp->jmp_address = cmd->addr ? be32_to_cpu(cmd->addr) : CONFIG_SDP_LOADADDR; sdp->state = SDP_STATE_TX_SEC_CONF; sdp->next_state = SDP_STATE_JUMP; break;