From patchwork Sun May 3 14:19:50 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Peng Fan X-Patchwork-Id: 244907 List-Id: U-Boot discussion From: peng.fan at nxp.com (Peng Fan) Date: Sun, 3 May 2020 22:19:50 +0800 Subject: [PATCH 06/13] thermal: imx_tmu: Check the TEMP range for iMX8MM In-Reply-To: <20200503141957.14635-1-peng.fan@nxp.com> References: <20200503141957.14635-1-peng.fan@nxp.com> Message-ID: <20200503141957.14635-7-peng.fan@nxp.com> On iMX8MM, the V flag in TRISTR register only reflect the state of SNSR value, not the calibrated TEMP value. So checking this flag is not reliable. Per IC suggestion, change to read the TEMP/AVG_TEMP directly and check whether it in valid range 10-125C. Signed-off-by: Ye Li Signed-off-by: Peng Fan --- drivers/thermal/imx_tmu.c | 14 +++++++++++--- 1 file changed, 11 insertions(+), 3 deletions(-) diff --git a/drivers/thermal/imx_tmu.c b/drivers/thermal/imx_tmu.c index 2a08d5085c..c577b0bd6c 100644 --- a/drivers/thermal/imx_tmu.c +++ b/drivers/thermal/imx_tmu.c @@ -106,16 +106,24 @@ static int read_temperature(struct udevice *dev, int *temp) ulong drv_data = dev_get_driver_data(dev); u32 val; u32 retry = 10; + u32 valid = 0; do { mdelay(100); retry--; - if (drv_data & FLAGS_VER2) + if (drv_data & FLAGS_VER2) { val = readl(&pdata->regs->regs_v2.tritsr); - else + /* + * Check if TEMP is in valid range, the V bit in TRITSR + * only reflects the RAW uncalibrated data + */ + valid = ((val & 0xff) < 10 || (val & 0xff) > 125) ? 0 : 1; + } else { val = readl(&pdata->regs->regs_v1.site[pdata->id].tritsr); - } while (!(val & 0x80000000) && retry > 0); + valid = val & 0x80000000; + } + } while (!valid && retry > 0); if (retry > 0) *temp = (val & 0xff) * 1000;