diff --git a/drivers/ufs/ufs.h b/drivers/ufs/ufs.h
index 555f8a6857d..a1006b80e88 100644
--- a/drivers/ufs/ufs.h
+++ b/drivers/ufs/ufs.h
@@ -712,38 +712,169 @@ struct ufs_hba {
 	u32			version;
 	u32			intr_mask;
 	u32			quirks;
-/*
- * If UFS host controller is having issue in processing LCC (Line
- * Control Command) coming from device then enable this quirk.
- * When this quirk is enabled, host controller driver should disable
- * the LCC transmission on UFS device (by clearing TX_LCC_ENABLE
- * attribute of device to 0).
- */
-#define UFSHCD_QUIRK_BROKEN_LCC				BIT(0)
-
-/*
- * This quirk needs to be enabled if the host controller has
- * 64-bit addressing supported capability but it doesn't work.
- */
-#define UFSHCD_QUIRK_BROKEN_64BIT_ADDRESS		BIT(1)
-
-/*
- * This quirk needs to be enabled if the host controller has
- * auto-hibernate capability but it's FASTAUTO only.
- */
-#define UFSHCD_QUIRK_HIBERN_FASTAUTO			BIT(2)
-
-/*
- * This quirk needs to be enabled if the host controller has
- * 64-bit addressing supported capability but it doesn't work.
- */
-#define UFSHCD_QUIRK_BROKEN_64BIT_ADDRESS		0x2
 
-/*
- * This quirk needs to be enabled if the host controller has
- * auto-hibernate capability but it's FASTAUTO only.
- */
-#define UFSHCD_QUIRK_HIBERN_FASTAUTO			0x4
+enum ufshcd_quirks {
+	/* Interrupt aggregation support is broken */
+	UFSHCD_QUIRK_BROKEN_INTR_AGGR			= 1 << 0,
+
+	/*
+	 * delay before each dme command is required as the unipro
+	 * layer has shown instabilities
+	 */
+	UFSHCD_QUIRK_DELAY_BEFORE_DME_CMDS		= 1 << 1,
+
+	/*
+	 * If UFS host controller is having issue in processing LCC (Line
+	 * Control Command) coming from device then enable this quirk.
+	 * When this quirk is enabled, host controller driver should disable
+	 * the LCC transmission on UFS device (by clearing TX_LCC_ENABLE
+	 * attribute of device to 0).
+	 */
+	UFSHCD_QUIRK_BROKEN_LCC				= 1 << 2,
+
+	/*
+	 * The attribute PA_RXHSUNTERMCAP specifies whether or not the
+	 * inbound Link supports unterminated line in HS mode. Setting this
+	 * attribute to 1 fixes moving to HS gear.
+	 */
+	UFSHCD_QUIRK_BROKEN_PA_RXHSUNTERMCAP		= 1 << 3,
+
+	/*
+	 * This quirk needs to be enabled if the host controller only allows
+	 * accessing the peer dme attributes in AUTO mode (FAST AUTO or
+	 * SLOW AUTO).
+	 */
+	UFSHCD_QUIRK_DME_PEER_ACCESS_AUTO_MODE		= 1 << 4,
+
+	/*
+	 * This quirk needs to be enabled if the host controller doesn't
+	 * advertise the correct version in UFS_VER register. If this quirk
+	 * is enabled, standard UFS host driver will call the vendor specific
+	 * ops (get_ufs_hci_version) to get the correct version.
+	 */
+	UFSHCD_QUIRK_BROKEN_UFS_HCI_VERSION		= 1 << 5,
+
+	/*
+	 * Clear handling for transfer/task request list is just opposite.
+	 */
+	UFSHCI_QUIRK_BROKEN_REQ_LIST_CLR		= 1 << 6,
+
+	/*
+	 * This quirk needs to be enabled if host controller doesn't allow
+	 * that the interrupt aggregation timer and counter are reset by s/w.
+	 */
+	UFSHCI_QUIRK_SKIP_RESET_INTR_AGGR		= 1 << 7,
+
+	/*
+	 * This quirks needs to be enabled if host controller cannot be
+	 * enabled via HCE register.
+	 */
+	UFSHCI_QUIRK_BROKEN_HCE				= 1 << 8,
+
+	/*
+	 * This quirk needs to be enabled if the host controller regards
+	 * resolution of the values of PRDTO and PRDTL in UTRD as byte.
+	 */
+	UFSHCD_QUIRK_PRDT_BYTE_GRAN			= 1 << 9,
+
+	/*
+	 * This quirk needs to be enabled if the host controller reports
+	 * OCS FATAL ERROR with device error through sense data
+	 */
+	UFSHCD_QUIRK_BROKEN_OCS_FATAL_ERROR		= 1 << 10,
+
+	/*
+	 * This quirk needs to be enabled if the host controller has
+	 * auto-hibernate capability but it doesn't work.
+	 */
+	UFSHCD_QUIRK_BROKEN_AUTO_HIBERN8		= 1 << 11,
+
+	/*
+	 * This quirk needs to disable manual flush for write booster
+	 */
+	UFSHCI_QUIRK_SKIP_MANUAL_WB_FLUSH_CTRL		= 1 << 12,
+
+	/*
+	 * This quirk needs to disable unipro timeout values
+	 * before power mode change
+	 */
+	UFSHCD_QUIRK_SKIP_DEF_UNIPRO_TIMEOUT_SETTING = 1 << 13,
+
+	/*
+	 * This quirk needs to be enabled if the host controller does not
+	 * support UIC command
+	 */
+	UFSHCD_QUIRK_BROKEN_UIC_CMD			= 1 << 15,
+
+	/*
+	 * This quirk needs to be enabled if the host controller cannot
+	 * support physical host configuration.
+	 */
+	UFSHCD_QUIRK_SKIP_PH_CONFIGURATION		= 1 << 16,
+
+	/*
+	 * This quirk needs to be enabled if the host controller has
+	 * 64-bit addressing supported capability but it doesn't work.
+	 */
+	UFSHCD_QUIRK_BROKEN_64BIT_ADDRESS		= 1 << 17,
+
+	/*
+	 * This quirk needs to be enabled if the host controller has
+	 * auto-hibernate capability but it's FASTAUTO only.
+	 */
+	UFSHCD_QUIRK_HIBERN_FASTAUTO			= 1 << 18,
+
+	/*
+	 * This quirk needs to be enabled if the host controller needs
+	 * to reinit the device after switching to maximum gear.
+	 */
+	UFSHCD_QUIRK_REINIT_AFTER_MAX_GEAR_SWITCH       = 1 << 19,
+
+	/*
+	 * Some host raises interrupt (per queue) in addition to
+	 * CQES (traditional) when ESI is disabled.
+	 * Enable this quirk will disable CQES and use per queue interrupt.
+	 */
+	UFSHCD_QUIRK_MCQ_BROKEN_INTR			= 1 << 20,
+
+	/*
+	 * Some host does not implement SQ Run Time Command (SQRTC) register
+	 * thus need this quirk to skip related flow.
+	 */
+	UFSHCD_QUIRK_MCQ_BROKEN_RTC			= 1 << 21,
+
+	/*
+	 * This quirk needs to be enabled if the host controller supports inline
+	 * encryption but it needs to initialize the crypto capabilities in a
+	 * nonstandard way and/or needs to override blk_crypto_ll_ops.  If
+	 * enabled, the standard code won't initialize the blk_crypto_profile;
+	 * ufs_hba_variant_ops::init() must do it instead.
+	 */
+	UFSHCD_QUIRK_CUSTOM_CRYPTO_PROFILE		= 1 << 22,
+
+	/*
+	 * This quirk needs to be enabled if the host controller supports inline
+	 * encryption but does not support the CRYPTO_GENERAL_ENABLE bit, i.e.
+	 * host controller initialization fails if that bit is set.
+	 */
+	UFSHCD_QUIRK_BROKEN_CRYPTO_ENABLE		= 1 << 23,
+
+	/*
+	 * This quirk needs to be enabled if the host controller driver copies
+	 * cryptographic keys into the PRDT in order to send them to hardware,
+	 * and therefore the PRDT should be zeroized after each request (as per
+	 * the standard best practice for managing keys).
+	 */
+	UFSHCD_QUIRK_KEYS_IN_PRDT			= 1 << 24,
+
+	/*
+	 * This quirk indicates that the controller reports the value 1 (not
+	 * supported) in the Legacy Single DoorBell Support (LSDBS) bit of the
+	 * Controller Capabilities register although it supports the legacy
+	 * single doorbell mode.
+	 */
+	UFSHCD_QUIRK_BROKEN_LSDBS_CAP			= 1 << 25,
+};
 
 	/* Virtual memory reference */
 	struct utp_transfer_cmd_desc *ucdl;
