From patchwork Tue Jun 9 14:05:12 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Jagan Teki X-Patchwork-Id: 242009 List-Id: U-Boot discussion From: jagan at amarulasolutions.com (Jagan Teki) Date: Tue, 9 Jun 2020 19:35:12 +0530 Subject: [PATCH 1/3] rock-pi-4: Enable USB3 Host Message-ID: <20200609140514.132579-1-jagan@amarulasolutions.com> Enable USB3.0 Host support for RockPI-4 boards. Note that the Upper USB3.0 port is marked as otg and lower USB3.0 port marked as host, so this below log capture when USB3.0 mass storage plug in at lower USB 3.0 port. Log: Bus usb at fe380000: USB EHCI 1.00 Bus usb at fe3c0000: USB EHCI 1.00 Bus dwc3: usb maximum-speed not found Register 2000140 NbrPorts 2 Starting the controller USB XHCI 1.10 Bus dwc3: usb maximum-speed not found Register 2000140 NbrPorts 2 Starting the controller USB XHCI 1.10 scanning bus usb at fe380000 for devices... 1 USB Device(s) found scanning bus usb at fe3c0000 for devices... 1 USB Device(s) found scanning bus dwc3 for devices... 1 USB Device(s) found scanning bus dwc3 for devices... cannot reset port 1!? 2 USB Device(s) found scanning usb for storage devices... 1 Storage Device(s) found => usb tree USB device tree: 1 Hub (480 Mb/s, 0mA) u-boot EHCI Host Controller 1 Hub (480 Mb/s, 0mA) u-boot EHCI Host Controller 1 Hub (5 Gb/s, 0mA) U-Boot XHCI Host Controller 1 Hub (5 Gb/s, 0mA) | U-Boot XHCI Host Controller | +-2 Mass Storage (5 Gb/s, 224mA) SanDisk Dual Drive 040130e3ee554b7078843f4eb331646 Cc: Tom Cubie Signed-off-by: Jagan Teki --- configs/rock-pi-4-rk3399_defconfig | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig index 0d86fdc895..2487872219 100644 --- a/configs/rock-pi-4-rk3399_defconfig +++ b/configs/rock-pi-4-rk3399_defconfig @@ -28,6 +28,7 @@ CONFIG_ENV_IS_IN_MMC=y CONFIG_SYS_RELOC_GD_ENV_ADDR=y CONFIG_ROCKCHIP_GPIO=y CONFIG_SYS_I2C_ROCKCHIP=y +CONFIG_MISC=y CONFIG_MMC_DW=y CONFIG_MMC_DW_ROCKCHIP=y CONFIG_MMC_SDHCI=y @@ -35,11 +36,14 @@ CONFIG_MMC_SDHCI_ROCKCHIP=y CONFIG_DM_ETH=y CONFIG_ETH_DESIGNWARE=y CONFIG_GMAC_ROCKCHIP=y +CONFIG_PHY_ROCKCHIP_INNO_USB2=y +CONFIG_PHY_ROCKCHIP_TYPEC=y CONFIG_PMIC_RK8XX=y CONFIG_REGULATOR_PWM=y CONFIG_REGULATOR_RK8XX=y CONFIG_PWM_ROCKCHIP=y CONFIG_RAM_RK3399_LPDDR4=y +CONFIG_DM_RESET=y CONFIG_BAUDRATE=1500000 CONFIG_DEBUG_UART_SHIFT=2 CONFIG_SYSRESET=y @@ -48,6 +52,8 @@ CONFIG_USB_XHCI_HCD=y CONFIG_USB_XHCI_DWC3=y CONFIG_USB_EHCI_HCD=y CONFIG_USB_EHCI_GENERIC=y +CONFIG_USB_DWC3=y +CONFIG_USB_DWC3_GENERIC=y CONFIG_USB_HOST_ETHER=y CONFIG_USB_ETHER_ASIX=y CONFIG_USB_ETHER_ASIX88179=y From patchwork Tue Jun 9 14:05:13 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Jagan Teki X-Patchwork-Id: 242010 List-Id: U-Boot discussion From: jagan at amarulasolutions.com (Jagan Teki) Date: Tue, 9 Jun 2020 19:35:13 +0530 Subject: [PATCH 2/3] rock-pi-4: Enable PCI/NVME In-Reply-To: <20200609140514.132579-1-jagan@amarulasolutions.com> References: <20200609140514.132579-1-jagan@amarulasolutions.com> Message-ID: <20200609140514.132579-2-jagan@amarulasolutions.com> Enable PCI/NVME for M.2 Slot on RockPI-4 boards. => nvme info Device 0: Vendor: 0x144d Rev: 2B2QEXM7 Prod: S4EUNG0MC10012Y Type: Hard Disk Capacity: 238475.1 MB = 232.8 GB (488397168 x 512) Cc: Tom Cubie Signed-off-by: Jagan Teki --- configs/rock-pi-4-rk3399_defconfig | 3 +++ 1 file changed, 3 insertions(+) diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig index 2487872219..f3eeef0293 100644 --- a/configs/rock-pi-4-rk3399_defconfig +++ b/configs/rock-pi-4-rk3399_defconfig @@ -18,6 +18,7 @@ CONFIG_TPL=y CONFIG_CMD_BOOTZ=y CONFIG_CMD_GPT=y CONFIG_CMD_MMC=y +CONFIG_CMD_PCI=y CONFIG_CMD_USB=y # CONFIG_CMD_SETEXPR is not set CONFIG_CMD_TIME=y @@ -36,6 +37,8 @@ CONFIG_MMC_SDHCI_ROCKCHIP=y CONFIG_DM_ETH=y CONFIG_ETH_DESIGNWARE=y CONFIG_GMAC_ROCKCHIP=y +CONFIG_NVME=y +CONFIG_PCI=y CONFIG_PHY_ROCKCHIP_INNO_USB2=y CONFIG_PHY_ROCKCHIP_TYPEC=y CONFIG_PMIC_RK8XX=y From patchwork Tue Jun 9 14:05:14 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Jagan Teki X-Patchwork-Id: 242011 List-Id: U-Boot discussion From: jagan at amarulasolutions.com (Jagan Teki) Date: Tue, 9 Jun 2020 19:35:14 +0530 Subject: [PATCH 3/3] roc-rk3399-pc: Enable USB Gadget In-Reply-To: <20200609140514.132579-1-jagan@amarulasolutions.com> References: <20200609140514.132579-1-jagan@amarulasolutions.com> Message-ID: <20200609140514.132579-3-jagan@amarulasolutions.com> Enable DWC3 core, gadget for roc-rk3399-pc board. This would help to use fastboot by default. Signed-off-by: Jagan Teki Tested-by: Suniel Mahesh --- configs/roc-pc-rk3399_defconfig | 3 +++ 1 file changed, 3 insertions(+) diff --git a/configs/roc-pc-rk3399_defconfig b/configs/roc-pc-rk3399_defconfig index 80e7001481..046fb73858 100644 --- a/configs/roc-pc-rk3399_defconfig +++ b/configs/roc-pc-rk3399_defconfig @@ -12,6 +12,7 @@ CONFIG_DEBUG_UART_CLOCK=24000000 CONFIG_SPL_SPI_FLASH_SUPPORT=y CONFIG_SPL_SPI_SUPPORT=y CONFIG_DEBUG_UART=y +# CONFIG_ANDROID_BOOT_IMAGE is not set CONFIG_DEFAULT_FDT_FILE="rockchip/rk3399-roc-pc.dtb" CONFIG_DISPLAY_BOARDINFO_LATE=y # CONFIG_SPL_RAW_IMAGE_SUPPORT is not set @@ -61,7 +62,9 @@ CONFIG_USB_EHCI_HCD=y CONFIG_USB_EHCI_GENERIC=y CONFIG_USB_DWC3=y CONFIG_USB_DWC3_GENERIC=y +CONFIG_ROCKCHIP_USB2_PHY=y CONFIG_USB_KEYBOARD=y +CONFIG_USB_GADGET=y CONFIG_USB_HOST_ETHER=y CONFIG_USB_ETHER_ASIX=y CONFIG_USB_ETHER_ASIX88179=y